⚡ Gear up your RC game with precision and power!
This 5-piece set of 54-tooth, 0.8 module, 32 pitch plastic spur gears is designed for easy replacement and tuning of your RC vehicles. Compatible with popular 4x4 VXL Rally, VXL HPS, and HPI models, these lightweight gears enhance performance by allowing precise control over the final drive ratio, ensuring smooth and efficient operation for cars and boats alike.
J**T
Perfect for slash 4x4 vxl
The media could not be loaded. This is an exact fit for a slash 4 x 4 VXL. I’m sure it will fit anything. That is the this specification. Perfect quality no issues all 5 the same
L**A
Great fit
Perfect for the traxxas slash, rustler, and hoss. Little bit stronger then the stock ones, come in a pack of 5 and cheaper. Good quality.
F**E
Holding up better than what Traxxas sells
Kept tearing up. Traxxas ones got fed up about these cheap ones. Have yet to break one on my rustler 4x4 VXL on 3S. I do recommend not cranking down on your slipper clutch and turn your brake percentage down
N**A
Good value
Good value and fit perfect
N**N
So far so good rustler vxl 4wd
Replaced my stock spur gear and drove the hell out of my car to see if these were worth it. They have held up so far.
V**S
As good as factory traxxas 54t spur gear
Seem to be at least as good as the original traxxas part so far and the bulk quantity discount is great! Leaving this last gear that's not metal that way intentionally so I go through these plastic gears as to be expected when eliminating the slipper clutch. Still on my 1st one after a few hard runs so great so far
A**X
It fits slash 2wd great material and durability
This is a must have !!!great product at first I thought I was going to be easy to brake but when I accidentally put on revere while going 30mph it didn’t broke !!! awesome materials great packaging and 5 pieces !!! Can’t be more happy.
A**R
Doesn’t work with telemetry magnet holder!
This looks like the same as the Traxxas but it doesn’t work with the telemetry magnet holder for the Traxxas cars. This spur gear allows the center bearing to push too deep when tightening the slipper clutch. When the bearing fully seats, there is no clearance for the magnet holder on the telemetry system. I didn’t catch this when installing and destroyed my motor mount, spur gear, magnet holder, and telemetry sensor. It was about $65 in parts to destroyed. If your not using the telemetry system, this spur gear should work fine. Hoping to save someone else this headache!
Trustpilot
1 week ago
2 weeks ago
