Tnisesm/60pcs 2 Pin & 3 Pin 5mm/0.2inch Pitch PCB Mount Screw Terminal Block Connector (Can be Spliced) TN-T03G

NON STANDARD USE (but fun!)I'm a newbie guitar maker. I wanted to be able to quickly swap out pickups or capacitors. I saw other vendors selling pots with these preinstalled, so I thought I'd try it myself. The tines were just a little too thick to fit into the free-way 10 position blade switch I used, so I ended up soldering solid core wire to bridge the gap. Otherwise, they fit nearly perfectly into everything else.These work great. My only complaint is that when I stuffed multiple pre-tinned wires into a slot (most were 22 gauge, some was 24 gauge), sometimes they wouldn't stick when screwed into place. I think if I hadn't tinned them, or if they were all the same gauge, it wouldn't have been a problem. Also, the silicone coating on some of them was really thick, which made it harder to stuff other wires into the same slot. My workaround was to solder those wires together before putting into the slot, which kind of defeated the purpose of them. But, it was a great learning experience.Finally, the provided screw driver works, but you have to pay attention to the angle more than other drivers if you want it to work.

Like Granddad always said... "Good enough for who it's for". Good price, decent product

Of the ones that are complete, they all seem to be fine and work correctly.However, there is one that is missing both screws and one of the parts that squeezes the wire.It's completely unusable. The funny part is it was the first one I grabbed to use on my project.

train layout

Everything works perfectly, and for this price!

some will fit tighter than others, others will not fit at all into prototyping boards. but for the price, having a few that fail isn't too bad. I wouldn't use them for anything outside of hobby stuff where some failures are okay.

I used these on a wire intensive product. They provide good mechanical retention of wires 16awg or higher.They stack mechanically. I found it easier to build them up one piece at a time on the board. If you stack a run of them and then try and insert them onto a prototype board it’s just about impossible.

These worked great for my electrical project. I needed to connect 18 Guage wires to a pcb board that I soldered together. Just use a Good Phillips screwdriver. My Wera Screwdriver, 118022 PH0, worked perfect to tighten, it didn't slip, it didn't strip. I would definitely recommend. Fast arrival, well packaged, works great.