OptronicsILL70CBAWNFS Opti-Brite LED Awning Lights - Low Profile 11" White

Winnebago wanted much more. Exact replacement for a great price

It was very difficult to remove the base from the cover. It required multiple small screw drivers to pry the sides apart, and I was fortunate that I did not damage the item in the process. (Maybe there is a trick to take it apart, but that instruction is nowhere to be found). No screws or installation instructions. Otherwise, it was an exact replacement for fit my Winnebago Trend porch light that had deteriorated and a faded LED element.

Though they really look sleek and match the OEM units used on Winnebago Sprinter RV's they are not made that well and don't seem to last the test of time.Pros: Very bright, Sleek and match OEM lightingCons: Not made that well, installation must be carefully completed or damage can easily occur to light.Personally I don't think they were made with long term usage in mind. Simply intermittent on and off just to give some quick lighting outside your van. I have had 2 fail in 4 years.

Purchased to replace the outside light on ArcticFox camper, matched OEM light

Led's on my RV oem light was about gone and the clear cover was showing it's age. This light was much cheaper than one from the dealer. Looks the same and mounts the same.

Original fixture was down to 1 led from 11. Replacement fit perfectly. Easy to install. Installed on northwoods 2016 arctic fox 24j

I received this light and started to install it. After applying caulking and getting it set, I realized that the parts of the lights had been previously removed and then reattached upside down. It received this light and started to install it. After applying caulking and getting it set, I realized that the parts of the lights had been previously removed and then reattached upside down.. Avoid.

This is an exact replacement for our 2016 Travato exterior light. Our previous light became saturated with water and slowly started to loose LEDs. I don't know whether the previous issue was with poor Winnebago installation or the light itself. Replacing the light was hard because there was little wire exposed on the interior to which to attach to (and I didn't want to break the seal to the interior. The two pieces of the light were difficult to separate due to gasket cement. We'll see how long this one lasts (previous one lasted ~5 years).

Easy replacement on an Arctic Fox camper

This light was an exact replacement for my 2015 Itasca Navion which is also the same for a Winnebago View. It was easy to install and works great. I am happy to have a good light once again.

I have not installed just yet, waiting for a nice day to swap out my old light. I only wish the packaging had instructions on how to separate the light into two pieces to prepare for install. I understand it snaps together but I don't want to break it, opening it up.

I wish they would send the direction on how to install.