Endurance Pro EP670 SM670 Universal Utility Blower Motor Kit Compatible with Supco 3000 CW/CCW 120V GIDS-631102 653026 250340 250355 33-670 90970

Worked great very easy to install

Worked perfectly! Easy to install

I bought these after trying two other brands that claimed to have the right shaft size but didn’t. These Endurance Pro EP670 / SM670 motors were exactly as listed. I was able to replace 2 of the 4 blowers on my 50-year-old wood stove insert, and the difference is huge. They move air much better and brought new life to an old setup. Highly recommend for anyone restoring or maintaining an older stove.

A friend had an old electric heater that was still in good condition except for the fan motor. I used this motor for the replacement. It was easy to reverse the rotation. The fit was perfect and the price was great. The heater now has new life and should last for years. I recommend this shaded pole motor.

Very good universal replacement exhaust fan motor.

This motor was a replacement for the condenser motor in my EdgeStar IB120SS ice maker I purchased back in 2015. When I purchased it, there were a lot of reviews stating it only lasted 2 to 3 years. Sure enough, around the 3 year mark, my ice maker developed a squeal. It was the bearings on the condenser fan motor going out.Cheap sleeve bearings.It was easy to find a replacement for that motor (this one) and it did fix things up nicely. Then about 2 years later, more squealing from the motor...It just started squealing again. I'm TRYING to track down a ball bearing motor (this will be the FOURTH motor I have put in this ice maker since 2015) that can be used in place of this ultra cheap sleeve bearing motor with little luck so far.In short, they work. Just not for very long.

Used as a replacement cooling fan for a Lincoln AC225 crackerbox welder. Fit right in, just had to remove and swap ends with the armature to get the mounting bolts looking the right way, took 5 minutes. It replaced a 240 volt motor that moved 350ish CFM and cost around $100. At 400ish CFM this motor does a better job cooling. It sounds exactly the same when you switch on the crackerbox welder, fan goes to whirring.

Doing the job! The only complaint is the noise level - it is perfect if it can be a little quieter.