TAILONZ PNEUMATIC 1/4 Inch NPT 24V 2 Position 2 Way Normally Closed Electric Solenoid Air Valve 2v025-08 Outlet Wire

works perfectly!

Got this for the horn on my truck, the solenoids that are made for truck horns kept failing. This solenoid is much higher quality.

Works as expected, no leaks, fast response

I got this to help with my air assist on a laser. After wiring it wouldn’t turn on so I thought it was my wiring. It was not after careful inspection. It was the unit that was broken. Power came in but the switch did not work. Replaced it for the pre wire one and that one worked well. Over all it’s good just test before fully assembling.

As expected. Works perfectly.

Was nice while it lasted. Until it wasn’t. Installed it less than 2 weeks ago with minimal use. This is the second one bought. First one stopped working as well but didn’t overheat and cause melted plastic worms to come out. Yes, it was hooked to 24v in case you were wondering. It also shorted my laser out and made it stop working. Luckily it didn’t damage my laser.**UPDATE:I contacted the seller and they quickly responded and sent me a new one. However, the new one was hooked up and I was having more issues. After racking my brain I decided to pull the valve off and start from scratch. The thing was super, super hot. Once I let it cool down I took it off and that’s when I noticed it. The valve said it was 12V! The box said 24V and that’s what I ordered. I have to fine the old ones and I’d bet my right leg that’s what happened to the others. So, I contacted the seller again and they are checking their inventory and sending me a new 24V one. I hope. The one I was ordering is not marked as “Unavailable”, so I assume their stock is messed up. I was just contacted and they shipped the new one. Looks a little different but will operate the same.I say all this to say…. Triple check the writing on the valve itself before installing it. Thank god it didn’t start a fire and/or burn up my $3k laser. The seller has been great with fixing the issue. I was able to work around the valve while I deal with this so I’m not too mad.

I’m not an electrician but I was able to wire it up the 12 volt version just fine. The solenoid says it needs 400ma but I read another review that said it got hot under that load. I tried a 200ma (typical cell phone adapter) adapter and it energized the solenoid just fine. If you are new to wiring, just open the unit by unscrewing the only screw visible. Pull the clear unit off (it will be tight). Looking at the clear unit, Remove the electronic bottom portion from the clear portion (I used the screw to pop the clips in the screw hole and it came right out.) Strip the wires. You’ll see three set screws. Thread the wire through the clear housing and wire one lead to each of the top two set screws (leave the bottom one alone). Put it back together.Again, I’m not an electrician. Please have a licensed electrician approve all work.

Purchased this to construct a temperature controller for a low-pressure steam heater. So far it has worked perfectly and with the PID it supplies the necessary heat in our production area. Tailonz products are well built and cost effective.