Short Brake Clutch Levers Compatible with GROM MSX125 2014-2019, CBR250R 2011-2013, CBR300R/CB300F/FA 2014-2019, CB400F/CB400R 2013-2015, CBR500R/CB500F/X 2013-2019, Monkey 125 2018-2019,Red

I installed these on my Grom. Perfect fit and function. I don’t know what the factory handles felt like because of buying a wrecked bike, but these seem like they would be an improvement.

They are nice, had to replace because a screw fell off...they come with no screws....

Great levers compared to the stock levers on a grom, feel great in the hand

I have small hands so I wanted adjustable levers for my Honda CB500X. These are easy to install and have good fit and finish. The only negative for me is the lever position at rest. With both levers set at the same position the distance between the grip and the lever is 0.60 inch greater on the clutch side compared to the brake side. The clutch is easier to reach than the stock lever, but I would like it just a little bit closer. I have the brake lever adjusted to position 4 to give enough room to use two fingers for the brake and not pinch my other fingers. Note: these levers are shorter than stock. Two to three fingers are all that will fit.

I installed these levers on my 22 Honda Monkey. They are good levers for what they cost. the adjustability is nice but the last two settings were the only ones that were usable for my big hands.

The coating looks good and the adjustments work great.. but the levers just don’t feel sturdy at all and have a lot of movement compared to the stock levers on my Honda grom. But for the price I guess I can’t complain too much.

Installed these on my CB 500x and I really like them. Super easy to install (unless you have no mechanical aptitude) and so far have worked perfectly. I've dropped the bike several (maybe more than several!) tubes on muddy and rocky trails and neither have broken yet.Lots of comments about sloppiness in the vertical play of the levers but that doesn't bother me nor has it affected their function.They look clean and crisp as well.Worth the money to me.

Added these to replace my MZS levers that had soon the anodized coating a bit. The brake lever went on perfectly but the clutch lever perch hole for the screw was slightly too tight. Fortunately I own a Dremel and just use a ball shaped sander bit to hone it out the little bit it needed. After that it went on perfectly. For $26 you can't complain too much.

I got the clutch and brake lever, the clutch works fine but the brake lever was not compatible