Hobbypark Universal Stainless Steel Centre Drive Shaft CVD 110-155mm for 1/10 RC Crawler Axial SCX10 RC4WD D90 Redcat Gen7 /Pro(2-Pack)

Strong can handle 6s 25v longer than my axle and transmission. The only problem is they use a u-joint instead of a CV.

Great at first but after about a month of getting after it on the rocks the u joints are trashed

I like that the product works. They are a little noisey covers all the other noise of your rig. Hard to hear if there is any other issues if any on your rig.

These things are tough and they're great

the holes are abit miss milled but go on with a tap here and there

I ran these for about 2 weeks before realizing how much slop they introduce to the drivetrain after the pins begin to stretch out the linkage at the U-Joints.I think they're made of copper (or some softer alloy) and coated with chrome. While they look good for a while, looks aren't everything.I switched back to the factory plastic axles for my Gen7 and I am much happier. I would rather break a plastic axle than suffer a more expensive part failure elsewhere, like in a differential of transfer case. These will sit on the bench and act as a last resort replacement if I don't have anything to use.

Great price fast shipping.very nice construction tuff shafts

Strong but not a through screw like stock on my redcat gen 7. So i have to keep tightening them. Maybe install with loctite

Driveshafts feel fairly solid. A bit sloppy/loose. clicky clacky.These driveshaft done like to be put on a very steep angle, the more neutral the drive line is the happier these are.Not sure if I would buy again.

Complete garbage. The joints are so loose I sore at first they were used. They aren't used but just super junky. The picture I took shows the difference between these pieces junk and the punisher shafts I already had.

Beau drive shaft mais en stainless mon c%#%@&@^# . Et une dizaine de sortit avec mon rc et les joint sont tout lousse presque cassé . Donc pour le prix sa ne vaut vraiment pas la peine de prendre ces pièces

Very strong and will work for crawling, but the assembly is very loose and the tolerances are not very accurate so the shaft is not balanced at all and is very wobbly. This caused the shaft to break my output shaft on my transmission. BE CAREFUL

Wanted something that would not rust out for my Redcat crawler, only lasted an hour walking in a park before on of the the universal joints failed.