Genuine Dometic OEM Water Heater Element Power Relay, Replace Your RV Water Heater Power Relay, Simple and Easy Installation - (93849)

It was easy to install took less than two minutes works great good quality thanks again

Guess what? It works. Just like the one it replaced. Shocking developmwnt

This relay is for many models of 2003+ Atwood heaters e.g. GCH10A-4E and operates via a 12v input switching a 110v supply to the electric element when the thermostat opens. The yellow wire from the circuit board goes to one 12v terminal and a ground/earth wire goes to the other. These terminals are conventional male spade terminals but smaller than standard. The remaining two standard male spade terminals are for the black 110V supply switched to the element. It's a 5-minute job to wire and fit IF you have access to the rear of your water heater. Most RV manufacturers competed to see who could make life as difficult as possible and prevent you from getting the rear components (element, relay, check valves etc.) and I figure it was a draw. I cut an access hatch with a jigsaw in the aluminum floor of my Winnebago once I got the heater out, and fitted a screwed & siliconed overlapping aluminum panel to the underside for future access. Honestly - it's a must. Now, everything is to hand, just like they should've made 'em in the first place. Anyways, great relay, fast shipment, and not expensive. If you need one, here's the place to get it.

It fit in water heater as expected and performs well. Electric water heater is now working as it shoudl

Good fir

Part was exact fit. Customer bought aftermarket spent hours diagnosing Waste Of Time Ordered OEM repaired issues minimal time aftermarket parts just don’t work you have to resort to OEM save time and money.

Old relay welded the contacts shut after 9 months of incessant cycling and I came home to a boiling and spewing hot water heater. Upon removal of the old relay I found the female spade connectors to be relatively loose. Squeezed them down with a pair of needle nose pliers, and installed the new relay. So far so good, water heater is back to proper functioning, and I don't hear anymore clicking from the relay

after taking everybodys advice for no hot water on electric changing the controller the element and thermostat no one mentioned that relay when i found out that was a relay behined the water heater i got this one and now it is fixed