Micro-Swiss - All metal hotend kit for CR-10 printers

Excellent build quality. A full metal nozzle is less forgiving though. It requires more tuning for each material. So, stick with a good filament supplier once you found the setting that works for you. Controlling oozing is very challenging as it will clog above 1mm retraction.

It is what it says on the tin, a direct replacement for the existing hothead I got it to allow me to print materials that required hotter printing temperatures. Not actually done any of them yet but it works fine with my standard materials after I got the printer settings tweaked to match it. I will be trying other materials with it soon.

Well built and easy to fit - hole for heater very tight (I don’t think I am gonna be able to get it back out without damaging it) takes a bit of trial and error getting print quality good but works great once you do

Worked like a dream.Before installation I was getting a number of blockages in the hotend due to heat creep and couldn't get rid of it no matter how much a mucked around with the slicer and wasted half a role of filament attempting to dail it in.Bought this and it was essentially plug and play and with a bit of PID test and tweeking, it worked brilliantly

I have been trying to print with these hotends as people have been saying how good they are. I can get them to print but everytime I have to do something with the nozzll after I've used it a few times. When I tighten the nozzle back up it shears and the nozzle is cut in two. twice this has happend and at £20 for a heater block and £15 a nozzle its a expensive do. I cannot recommend these

dont settle for the stock hotend its poor ..swap out with this and away go s the nightmare of the clicking feeder due to the stock hotend burning up the internal ptfe . I no you need this you no you need this only stop being a tight ass its a bit more than a standard replacement but u will only need to fit this once .

One of the best upgrades you can make on a CR10/Ender 3/Ender 2...worked straight out of the box and really was easy to fit to my printers. Just follow the instructions (and adjust your new hotend z height before homing) and you should have no issues in fitting this hotend. Print quality is excellent and now I can print with special higher temperature materials as the Micro Swiss is an all metal design...highly recommended!

Very high quality and well made. Easy to follow instructions on the Microswiss website.Fantastic upgrade, very much recommended.