Multimeter Test Leads Kit, AMTOVL Electric Multimeter Test Cable with Alligator Clips, Test Probe, Spring Grip, Banana Plug - Voltmeter Cable for Voltage Circuit Tester (12 PCS)

This is a very handy set of test leads and they are well made. They will cover a wide range of uses where you need to attach a Digital Multi-meter or to connect a DC PSU to charge a battery. The leads were well priced and cover all my needs, so I recommend them.

I am rarely so pleased with a purchase as this!The main cables seem to be silicone not PVC as they're quite bendy and "rough" feeling not shiny smooth and inflexible like PVC. Average length. Obviously not really 1000v/20a rated.What's really nice about this set is that the main cables are basically just extension leads. Don't get confused like I initially did and thought I had to plug the banana plugs into that and everything else into them like a big daisy-chain mess - you can plug everything directory into the cables.The large alligator clips are pretty huge, you could practically jumpstart a car with them. The smaller ones are more my thing (hobby/DIY) but note they are nice quality, covered and not so fierce that they'd bite through any wire you attached to them - unlike your run-of-the-mill crocodile clips.The 4 nickel tips are the same size, as are the 4 gold ones; so basically you get 2 sizes. I really like the cover for them too - saves you getting your fingers burned or interfering with the readings - or bending the tips like my last pair. I don't seem to have any problem screwing them into the ABS probes.The banana plugs and spade terminals give you expansion capability - you could plug pretty much anything onto the ends of those or even use them with your bench supply or scope.The only bad thing I can report is the mini test hooks - they really are tiny/flimsy and the connection is a Dupont female and the other end goes on top of the nickel tips (barely!), this is the only part that doesn't go straight onto the main cables. They're not quite as fragile as regular test hooks you get but they do seem like an afterthought to add value/gimmick.If the test hooks were better and the price was less that £19, I'd have given it 5 stars for value; but it gets 5 stars overall.

Used for basic connection of older Tektronix equipment. Not top quality, but adequate for initial testing purposes. A good range of connectors.

This is a well-made set of probes and leads that should cover most requirements. The set is based around a pair of extra-flexi leads that terminate with shrouded male 4mm connectors, One is straight and one is right-angled in each case. Supplied to fit are a pair of crocodile clips, and standard probes, complete with various screw-in points. All connections are shrouded 4mm. A good quality set at a good price.

I don’t know much about multimeters but this does seem like a very good set. I especially like the silicone leads. The crocodile clips are top notch too. All in all I think this is a very handy set to have.

Leads are short extension leads included would be nice, took ages to find some plug in extentions.

I got fed up with routing in my meter draw for correct leads etc. and these are simple but comprehensive. So good I bought a second set for my other meter.

I bought the 8 piece kit and the probe leads and the mini hooks plug into my UNI-T UT70B meter no problem. The crocodile clips are the problem as they have a crimped connector that you push the probe tip into which is not the grippiest of connections and is easy to pull the clip off, once you have pushed the probe tip in and out a few times it gets loose to the point of being not usable, why did they not supply the small crocodile clips that are supplied in the 18 piece kit they sell, they would plug into the end of the leads and not be a problem, I will see if I can solder the crimped ends together and beef them up a bit to maintain a good grip.