GXP Bellowed Up Pipe Kit with NON-EBPV Pedestal & Exhaust Housing Compatible with 1999.5-2003 Ford 7.3L Powerstroke Diesel

I don’t like to leave many reviews but for this set I have to. Went on my 7.3 excursion almost a year ago and have not had any problems. Make sure you leave all the nuts loose on the down pipes till you get everything on. It’s a tough job to do with transmission in but it’s doableWell worth the money

Everything in this kit was great! The pedestal mounted perfectly and the down pipes with the turbo mount fit right up to the turbo. All you have to do is leave the bottom of the down pipes loose, along with a slightly loose turbo and it fits perfectly. The pipes "ARE STAINLESS STEEL!"

It's a good overall product that came with grade 8.8 hard ware for installation. All pieces fit just right where they were supposed too.I did have Two minor problems withe the cast pieces. The exhaust collector had some raise casting that wasn't properly machined away for smooth exhaust flow. The turbo outlet had one bolt hole where the casting wasn't machined down right and the bolt head was sitting on a very small sharp lip. Both were easy to fix but should have been caught by their quality control.

Everything fit perfectly.

No problems installing, bought o rings from ford instead of provided rings just incase.

BUYER BEWARE!!!! After installation, took my truck for a 15 minute test drive, and upon inspection found new oil had leaked from somewhere into the valley and also left baseball size spot on the ground under the truck. Had to start taking parts off again to determine where the oil was coming from and discovered it was leaking out of the small plug screwed into the back of the turbo pedestal. I am beyond pissed off. I have to remove the turbo and pedestal again in order to tighten the screw and HOPEFULLY it won't leak after that.

Quality kit that doesn’t kill the bank. Everything lines up. Just a tip, leave the bottom up pipes loose when mounting to the turbo.

First off, the up pipes are pretty nice stainless steel. The welds were good on them. The hardware is as to be expected it's not ARP but will get the task done. The casting on the "Babies butt" turbo flange is not the greatest I don't see it being problematic in the future, but it looked rough. The hot side delete plate fit fine no issues from that. If you have leaking up pipes and, on a budget, I would defiantly purchase this kit to get the job done. Second that if you have a leaky turbo pedestal. Pedestal worked fine, however the Orings are questionable. Trick to install leave the lower up pipes that connect to manifold lose when mounting turbo!!!!!