It's designed with development in mind and has an expansion header that enables developers to expand the platform as well as good software development support. Due to it's small size it's perfect for developing new software and can easily be flown inside. It can lift a payload of up to 5 - 10 g. This is the 10 DOF version of Crazyflie that integrate extra sensors for altitude and heading measurement. The Crazyradio can be connected to a PC (with support for Windows and Linux) but also to other hosts that support USB Host or OTG like Android phones. Mac OSX currently has beta support handled by the community. The Crazyflie Quadcopter is shipped pre-programmed and can easily be wirelessly updated via a radio bootloader from a host PC, so no JTAG is required for reprogramming. For advanced development and debugging there’s also an accessible JTAG interface. Note: This kit requires soldering skills. Crazyflie features: Small and lightweight Flight time up to 7 minutes with standard 170mAh Li-Po battery Standard micro-USB connector for charging (takes ~20min) On-board low-energy radio@1mW. Up to 80m range (environment dependent) Radio bootloader which enabled wireless update of the firmware Powerful 32 bit MCU: STM32F103CB @ 72 MHz (128kb flash, 20kb RAM) 3-axis high-performance MEMs gyros with 3-axis accelerometer: Invensense MPU-6050 3-axis magnetometer HMC5883L (compass) High precision altimeter MS5611-01BA03 Cortex 10-pin JTAG (header not included) 4-layer low noise PCB design with separate voltage regulators for digital and analog supply Kit includes 1 x Crazyflie control board 1 x Crazyradio 1 x Duck antenna 2 dBi 5 x Motor mounts 5 x Coreless DC motors 5 x CW propeller 5 x CCW propeller 1 x LiPo battery 1 x 2*5 pins 1.27mm (0.05”) pitch header. What is not included but needed for flying - Micro-USB cable for charging - PC compatible joystick - PC
A**Z
Four Stars
Great product, but hard to fly
Trustpilot
1 week ago
3 weeks ago
