1/2" Shank Flush Trim Router Bit Bottom Bearing; Top & Bottom Bearing Trimmer Router Bit Woodworking Cutter Wood Trim Cutter

This bit is a monster. Use at low speed

Spend the extra money on something not using cheap Chinese steel. Also, make sure you check and tighten the hex screws down before and after EVERY use. Works ok, if you need to edge route boards. If you need to do complex curves, like routing a guitar body from a template, forget it, or be careful around corners, as it tears out chunks of wood if you're not careful. Doesn't stay sharp. Wouldn't recommend... would advice to pay more money for something more quality, like bits from Whiteside.

This router bit is a piece of junk. It was dull the screw and bearing at the bottom was offset. I used it to make one cut and the bearing fell off and the set screw on the top coller fell out. I threw it in the garbage.

Product is very good quality for the price. Need a taller bit to create a flat edge for some red oak stair treads that were made out 2in thick rough sawn oak and this did just the trick. Far cheaper that a jointer since a already owned multiple routers. Only down side is the bearings could be a bit better since they were pretty wore out after making 13 treads but for the cost they did the job.

I bought this to trim down a door I was installing and didn't want to use my electric plane(don't have much experience using it). It arrived fast and I've checked the bearings to make sure it was secured before use. It gave a nice clean cut.

After arrival use of bit, it will have to be sharpened.

Nice sharp edges, nice clean cuts..

Arrived as described.