Benchmark Abrasives TCT 7 1/4 Inch Circular Saw Blade, Tungsten Carbide Tipped Metal Cutting Saw Blades for Cutting Metal, Stainless Steel, Ferrous Metals, Miter Saw Blade (7-1/4" 52 Teeth)

Installed on my makita cordless small circular saw for cutting conduit and pipe. Have been running it for a few months and it is holding up very well. Blade stays sharp and fits well. Cuts fast.

What can I say, bought for a good price and works like it should. Using for cutting Legrand Wiremold 700 raceway. It provides a quick smooth cut.

I wore goggles, but if I were to do this again I would have worn ear protection. screaming loud. Also the metal chips were extremely fine, more so that I was expecting. they got everywhere, embedded them selves in the soles of shoes and in the most unlikely places. Splinter-fine. Next time I would have used a drape cloth and been more concerned with containment.

I bought this blade to cut a piece of 20 AWG embossed stainless steel sheet to size, on my DeWalt table saw. The blade comes with a hole to fit a 1-inch arbor, but it comes with a spacer washer to fit a 5/8-inch arbor on the saw. It works more like an abrasive cut-off wheel than a saw. It forms a red-hot strip of kerf, so be sure to wear safety glasses. It did a fairly neat job, with a slight burr to the edge of the cut.

Benchmark is a great company and this is a great blade.

I read a review that said only made one cut and blade was shot. Another one said had a tooth break off. I just figured those people didn’t know what they were doing or happened to get a bad blade because others had ok experiences over all. I didn’t even get a full cut on a 1”x3” 18GA (light gauge) stainless stock and a tooth broke completely off and chipped another probably 6 teeth. VERY DANGEROUS BLADE. I definitely would not buy again. Bought a Diablo Steel blade and noticed a huge difference in speed and ease of cutting. Probably have about 8 cuts on the blade and I am now starting to notice the blade is now cutting a little slower. Spend the extra $10, it’s well worth it.

i can't recommend these blades. i got maybe a few dozen cuts in 1.25 sch 40 pipe before it started shearing teeth off and fighting to get through the cut. as compared to the diablo blades that i usually buy i get typically hundreds of cuts before they start to show any signs of wear and then another few hundred before i have to push. not only that but they run much louder and show balance issues right out of the box whereas the diablo blades always run quiet and true. spend the extra 15 bucks on the freud blades.

Gets the job done. Got through a 3/4" diameter cold steel bar (not hollow pipe). Blade dulled, but teeth all survived.