BOSCH RC2144 7/8 In. x 12 In. SDS-plus Rebar Cutter

I ordered this product as a last resort for a job that had 30 holes that hit rebar. We had been having bad luck with the two different core drills that we rented. This bit drilled through the rebar in all 30 holes faster than the core drill rigs that I had on site. When I saw how fast this bit was drilling through the rebar, I put away the core drills and used the rebar cutter exclusively. By the end of the 30 holes, the bit had lost a tooth, but it was still working.I would definitely order it again in the future. I'm sorry that I wasted money renting the core drill rigs and buying the bits - that's $100/day for the drill and $130 for each bit. This $65 bit did the job instead.

Bit drilled through a reinforced masonary wall that a diamond core bit couldn't. Used drill only setting on a SDS hammer drill; slow going but got the job done. Bit teeth look fine with little to no wear.

Trying to install my 2 post lift, I ran into a piece of rebar directly in the way of one of the mounting holes. After fighting with other bits for a while, I decided to just buy this thing. Worth it, this thing cut through the rebar in about 10 seconds. No problems.

This is a great cutter for going into concrete with rebar. I was installing my car lift in my garage and was trying to drill with regular concrete bits, which didn't work well even in the concrete, but especially when I hit rebar. This Bosch bit worked very well - took about 5 minutes for each 6-7" deep hole until the 10th one when I hit rebar dead on. That last one ripped the teeth out of the tip and the bit was done. Bought a second one that went right thru the same piece of rebar.

just what i needed

Didn't make it through 1 rebar before breaking all the carbide teeth off.

After fighting to cut thru 1/2 inch rebar with the Diablo brand concrete/rebar 3/4 cutter, I purchased the Bosch 3/4 rebar cutter bit as a last resort. After about 30 seconds the bit successfully cut thru the rebar and allowed me to finish my job. Used with a Makita rotary hammer drill set on drill mode only! Thank you Bosch for a great product! Highly recommended!

Easily drilled through rebar in about 10 minutes. This was after struggling for 1.5 hours to drill through rebar with a standard carbide hammer drill bit.

Amazing!! Will cut through bedrock ! It was a lifesaver ! Drilling holes into bedrock to set anchors , became an easier task once we received this item . Well made . Bosch you made it well, thank you

Cuts rebar very easily. So much better and effective compared to a Hilton cruciform CX

Boa qualidade

I bought this because I encountered rebar when drilling for concrete anchors to install a two post lift in my garage. I only needed it for two holes but it worked extremely well. It chewed right through the rebar and allowed for a nice clean hole.

Bad luck that under a line of holes for some concrete anchors to attached bases for the posts for my gazebo, was rebar the entire length. Took a while but eventually using this bit I cut through the rebar at 8 different hole locations. It was my only hope and this tool came through for me.