Titan Controls Ares 4 - Carbon Dioxide (CO2) Generator LP - 10.6 CUFT/HR, 4 Burner, Liquid Propane, White

Good product.

I ve liked it so far, dont believe all the bs on here about heat and propane leaks. This is a simple device that works perfect. You will save lots of money on co2. The heat is minimal. im down south and choose to run this over bottles. it is 80 and 90 outside most of the time. lots of bugs come from switching out bottles the bottle you have today may have been at some total pigs garden two days ago, if they got spider mites so do you. This is the answer

This is a HIGH QUALITY Generator and paired with the Autopilot APC8200 Controller is an unbeatable combination. My Grow Room is well sealed and I'm very impressed with how little energy is used. I'm expecting that a 15 lb Propane Tank will last at least 3 Months.

I am purchasing my third one, and as the header states, at least as much for the use as a heater as a CO2 generator. Any simply hydrocarbon burner will produce CO2, but with this unit the power can be easily controlled via temp, or CO2 levels. This unit will put out as much heat as the tank mounted heater I was using did, and more. Doubt I will use this unit in the warmer months, but in the winter, it is a good way to go.

Works perfect with the matching controller. Easy to install

With addition of this controller (Autopilot APC8200 Monitor & Controller, Remote Sensor, Blue), I am able to keep my flower room a 900ppm with a 400ppm variable (high 1100 - low 700), the room is 18'x20' and I consume a 20# LP bottle every 11-15 days. If you are running commercial lights this unit is very beneficial to plant growth.

When I received the package box was a little damaged I didn’t think anything was wrong until I unpacked the unit and two little nuts fell out of it just from picking it out the box, could not see where they had to go? Hooked it up and worked as it should of. Installed the unit today and it would not work, moved it all around to reset the leveler switch and the light flickers, still not on... so I give it a quick shack and something in the control panel is loose and wiggle around when i shack the unit it’s flickers on and off with the wiggle so somethings not connected correctly. I will be calling the manufacturer tomorrow and see what they do? Will update with their performance on this issue....

I love this thing. Together with the Titan controler/monitor it’s amazing. I used other Less expensive controllers and they worked for a cycle and after I had a hard time with calibration. There is no calibration necessary with the titan control. Totally worth it. I am a newbie and I’m learning a lot of things the hard way, one of those is don’t be cheap!