HFS (R) 46 Pcs Harmonic Balancer Puller - Gear Puller, Crank Shaft Pulley, Steering Wheel Kit Pulley Yoke Crank, Storage Case

I used it to remove the harmonic balance on my 350 Chevy and it worked well. I would not suggest using an impact wrench as you will likely strip out the threads.

My husband said this is exactly what he was looking for, and he said it is very good quality for the price. (He said he would buy it again.)

Pulled flywheel off a 24hp Briggs. Worked, but don’t really bear down on it. Get it tight, snug it up, tap the center threaded rod with a hammer, tighten, repeat. Make sure the bolts are fully threaded. After a good bit of persuasion, flywheel popped loose. Just be careful with it. Bolts aren’t best quality but it works.

Perfect for what I needed

Purchased this kit and it seems OK, however it didn't have the adapters that I needed for my application. I ended up sending it back in exchange for a more complete kit. For the money, and most applications, it would probably OK. It's of standard over-seas quality, however I think it would but just fine for most hobbyists.

Works as advertised

I was hoping to get the flywheel off my Ferris mower and found out a crowbar and a 3 lb hammer did the job while I was waiting on it to get here. It looks just like the picture and I needed one

It worked without a problem on 2005 F150 XLT 5.4L engine. Has the three correct size bolts for the crank pulley. This is an old rusted engine with 210,000 miles. Absolutely no problems, took less than 30 seconds with a socket wrench. I did put washers on the bolt heads to not take any chances. The washers are in the kit.