80 Piece Truss Head Screw Set for Dock Bumper Installation Marine Grade Stainless Steel 10 x 1-1/4 Inches SS

Checked with a magnet- not magnetic, beyond that induced by cold work from forming the screw. Even that is almost imperceptible. Appears to be a good product. Installation tip-- there are several comments about these being soft and easy to strip out. Well, they are. But that is their nature. It is not a defect. These are 300 series stainless steel. This material is used for its corrosion resistance, not its strength. They cannot be hardened like tool steels, or other high strength steels. They are intentionally sold in their softest (annealed) condition because that is where the corrosion resistance is at its best. So pilot drill your holes, and press hard on the driver and make sure your driver is not tipped off at an angle when driving. If you use a drill, set the torque limiter to the minimum necessary for your set up (test it in a scrap piece!). With this size stainless screw, most electric drills can rip the heads right off if over torqued. And if you tip off at an angle, you can easily strip the head. So I hope this helps. Good luck!

It’s worth the extra money to buy these screws for my Marina needs

As advertised 5 Star *****

I wish they’d make torque screws instead of Phillips because the screw is easy to strip out if your not perfect lining up when you screw it in. Other than that they’re good

We did not need to predrill a hole to put these into pressure treated lumber. These screws are on a dock and we screwed them through rubber prior to going into the pressure treated lumber. They have a nice big head that helped hold the dock edging material down. They are nice and shiny. The price I paid was the best price I could find for this size. Out of the 80 screws I had one screw that was not machined properly and I could not screw it in. I dropped several in the water and because they are so shiny I was able to dive in and retrieve them. The only issue I had was that the pan head is bigger than the opening on the drill bit extender sleeve. They are not magnetic so they can drop easily. For what I was doing we needed the pan head.

Solid screws.

Not bad, but be cautious. As others have stated, the head strips easily. Even after drilling a pilot hole, the screw head tend to strip fairly easy under torque. Had they made the driver on the head bigger and deeper, this would have allowed the use of a larger bit, which would give better grip. Instead they have a fairly small and shallow base for the size of the screw. Would not recommend if your going into any hard woods. Find something with a better head that can use a beefy driving bit.

Good Quality SS, FAST delivery

Rust after 6 months!! Crap. Want my money back!!