Heavy Duty Garage Corner shelving kit, 1 Corner unit 1800mm x 900mm x 300mm & 2 Shelving units 1800mm H x 900mm W x 300mm D Massive Storage Capacity of 4125KG

Bought to store all my tools and boxes in the new garden shed. Can be a bit fiddly to put together but a little patience and it goes together well. Plenty of storage space for all of my needs

Very strong and plenty of room for all tools

The shelving on the whole is very good but very difficult to assemble

Firstly the courier didn’t deliver the corner unit as the packaging had fallen apart and he wasn’t sure if all the parts were there, I’ve still not received that part of the unit. its taken 5 days so far to confirm with the delivery company that part of the order wasn't delivered.Secondly several of the brackets, uprights and bars were bent, some of the slots slightly too small- they seem to be bent inwards, and out of the whole thing only 3 or 4 parts slotted in easily even using a rubber mallet. Most parts needed to be straightened up to get them to slot together.Truly frustrating to construct but once the shelves were built they seem decent enough. Can’t review the corner unit as I haven’t received it. I’m sure once it’s all fixed to the wall it will be good.I’d advise you to leave your garage in a mess and buy a massive jigsaw with a couple of pieces missing because that would be less irritating than building this unit and you’ll probably swear a lot less.

Easy to assemble product accurately as described has made an amazing difference to garage

Great value for money.Took about an hour to assemble. Make sure you have a rubber hammer to hand as the clips need to be properly located to provide the sturdiness you need. I’m well impressed. The only addition I made was to bolt them together. Would buy again.

just what i was looking for fitted like a glove in my work shed an easey toassemble

As with others, the box for the corner unit was half open on arrival. Courier took photos in case there were parts missing but I seem to have been lucky.Assembly took a bit to get started as it's not obvious which parts are which (instructions could be clearer on this), but after you build the first level it makes a lot more sense.It can be massively frustrating to try and get the tabs from the horizontal bits into the vertical poles. I did have to bend some of the tabs to get the vertical pieces correctly seated as they tend to go in at an angle. You'll need to use a screwdriver to widen the holes for the tabs to sit in.The diagonal cross braces could use improvement as well as they tend to not stay in place when a heavy load is on the shelf.Otherwise this appears ok so far, but time will tell.Edit: shelves are covered in mould after only a few months. Wouldn’t recommend.