GX 340 Carburetor for Honda GX340 11HP Engine for Replace for 16100-ZE3-V01

What a deal, if you need to stretch your dollar, this is the best value for the money. Unbelievable, it shipped and showed up when it said it would. No issues with anything. I was like should I just buy a seal kit..nope for the money just buy this, it even came with the plug. Heck of a deal. Such a deal I ended up buying 2 more because I was told, "them things were awesome, can you get 2 more" I said sure and boom they showed up like the first time. I know that if any of our other trash pumps go out I will be ordering more. Did I say value for money, cuz if I didnt well they are and I would have done an unboxing video but you get everything pictured and they fit and work excellent.

My GX340 pressure washer had been sitting for at least 20 years with gas in the tank. The tank had rusted inside real bad. I dumped a box of sheet rock screws into the tank along with a container of scrubbing bubbles and let it sit for two hours and a half, shaking all around every fifteen minutes. It turned out clean as new!The carburetor fit mine perfectly and was a snap to install. The engine started on the first pull and ran perfectly, I didn’t have to adjust the idle, high speed, or low speed screws. I will recommend this carburetor to anyone who asks.

Worked perfectly

I ordered this for my father in law. He had a pressure washer that would not run good at all. Replaced the carburetor and now it is running like a new one.

Worked great right out of the box

Installed easy, but that’s where the good news ends. Would have returned it but waited to long to install. After replacing old one with this carb, Engine wouldn’t do more than a ROUGH idle. Adding RPMs would stall engine. Ended up replacing spark plug, didn’t help. Then replaced ignition coil, didn’t help. Checked valve lash, didn’t help. Purchased the Honda carb for an extra $20. Fired right up and ran like a new machine. I guess I just ended up with a lemon!

It was a bit different than the stock carb from the early 2000s I could have probably got it to work but I just ended up using the float and needle for the stock carb

I have a very old (about 25 years) Graco pressure washer with a GX340 11hp engine. It had been sitting in storage and not used for probably 10 years. The float bowl and gas tank were full of rust so I went to Amazon to see if I could find replacement parts. There are lots of carburetors that supposedly fit this engine but they all have different model numbers and vary slightly to the original carb. I spent some extra time comparing my old carb to the pictures of the new ones and found this one to be the closet match. It arrived on time and you can't beat the price. It took about 15 minutes to install it along with a new air filter and gas tank. Everything fit perfectly together and with 2 pulls of the rope it started right up and ran like it did when it was new. Amazing!P.S. I had taken it to a repair shop before looking on Amazon and the repair tech said to junk it. Glad I didn't listen to him