Display Technologies Fridge Organizer & Soda Can Dispenser for Refrigerator - Drink Dispenser & Refrigerator Storage (2-Pack)

Theses are amazing and perfect for my work fridge!! Doing monsters, sodas, fair life’s, waters, and sparkling waters.

Exactly what I needed. The trick was that the pins that come are for a met ad l gondola. I used this in a cooler and each holder has a notch s as LLC the under so it nestles only a wire shelf. Then to get a way to attach prices , I added a 2nd wire shelf directly under the shelf holding the rack.

Key notes: super easy to install (might want to score the snap/break points, if you need shorter lanes, with razor knife or sharp knife of sorts to prevent unwanted fractures in my opinion), my fridge holds 5 lanes on one shelf, can COMFORTABLY fit 6-16.9 oz ozarka water bottles in each lane, totaling 30 water bottles, however, 7 can snugly fit in each lane, if you so choose (wouldn't necessarily recommend, but possible) totaling 35 water bottles, a little on the expensive side, but worth it! Review: I like to put my water bottles in my fridge, and because the only place they all could fit was towards the bottom, they were very difficult to reach once the first two rows were gone. I thought to myself, "I need a drink pusher like they have in convenience stores!" I searched high and low for some, even went to the extent of calling a local coca-cola distributor to see if I could buy some off of them, obviously, I wasn't able to. These weren't my first choice, they ended up being my only choice, due to I couldn't find any elsewhere that would sell to an individual, and in a turn of events they became the BEST choice! I absolutely love them! They are so convenient! Easy to load and grab a nice cold bottle of water with ease! I am no longer having to do an army crawl on the floor, reaching in the frigid depths of the far back corner of my refrigerator just to get to the last row of water bottles! This product may be a little expensive, but it is DEFINITELY a win in my book! Not to mention, you most certainly get more than you need, so you have extra if you need it! Hope this review helps!

Great pushers. Use 16.9oz soda and a few 20oz sports drinks, and they all fit very well, and pushed product easily. You can mix and match how many rows you have a across each shelf and had enough for 4 full shelves in a small upright cooler. You also also adjust the length by breaking the back tabs off.

It was easy to customize length and width, but does not fit very well in the “older fridge” models. I have a garage fridge sitting about 5 ft tall and it holds 6 cans deep, or 7 water bottles. I was able to get 7 rows across. Also I had to remove the side rails on the door or it wouldn’t close. I could have made it not as deep and kept the door rails on. The water bottles don’t pull out very easy, prob cause the bottles are cheap plastic not really the fault of the product. But this a great conversation piece when friends come over for a beer. 😃

These are incredible. Easy to take apart and put back together. The work really well and are high quality. Made in the USA!

Absolutely worth every penny. I have 2 of each size and my Garage Refrigerator stays stocked! So much easier to see what needs to be refilled and what flavors / sizes i need to purchase.

Couldn't be happier with my purchase. I have a GCG-12f Upright Cooler from Monster Quick Specs Exterior Dimensions (WDH): 25” x 24.125” x 63.5” | 635 x 613 x 1613 mm Internal width of 21" available for racks. I have a total of 5 shelves inside but originally I had only installed 4 of the 5 given from Monster. When I purchased these display push racks I only purchased (2) packs which gave me a total of 4 plastic trays. Once it arrived (rather quickly which was great) I immediately started snapping off the sides and parts I wouldn't need after fitment. Racks come with 8 rows wide and in 3 sections. 1st section is 5 rows 2nd section is 2 rows 3rd section is 1 row Since my fridge only fits 6 rows wide i had to unsnap the double row and replace with the single. Well, to my luck that left me with (4) double rows that I was able to combine together with their current snap setup and gained a 5th (6) row rack for my 5th shelf I now installed 👍 Everything slides wonderfully as described. They even put a LIGHT amount of lubricant so it has a smooth start. But not to worry, it doesn't get on your drink products. Even comes with enough pins to keep the racks from sliding all over the place. Perfect! You can install them on leveled racks and they slide perfectly. but I personally put the rear shelf pins on my fridge racks 1 notch higher than the front. Reason is preventative maintenance, i figure with the slight reduction of gravity force it will make my racks last longer. But what do I know lol.