AFB Acoustical Fire Batts Insulation Board, Sound Deadening Mineral Wool, 2-inch, Case of 6

Worked better than I could have hoped for. Insulated the door, floor, ceiling, and walls of a 36 x 36 sound isolation booth, and covered the walls with 3" acoustic squares. The door, floor, ceiling, and walls were built by ripping 2x4's in half, sandwiching the fire batts between sheets of 1/4" luan plywood. Then adhering 3" acoustic tiles to the surface of the door, wall and ceiling for anechoic purposes. The floor was a 1" rubber mat. Used the booth to pipe in 110 dB of chainsaw sound for the purposes of demonstrating hearing protection. Noise on the outside of the booth was 68 dB, which is barely above ambient for a busy convention center hall.

The media could not be loaded.

To flimsy. I will have to stick two together in order to put up on my ceiling. Way overpriced

Works great for my sons' project to keep the reverb in his room minimal.

Very easy to cut with the bread knife.

works as avertised

Did the job but not strong enough to hold its own weight without ripping.

These suckers really deaden sound. I attacted to to a 2x4 foot waffle board and wrapped with an old bed sheet for some sound isolation around the drums in my basement. Worked just as intended. Shipping was a bit much for these, in retrospect I would have gone down the street to the industrial supply place and picked it up for 15 bucks more to have it a week earlier rather than pay exorberant shipping rates.