Two Little FishiesATLCF2 Coraffix Cyanoacrylate Adhesive, 2-Ounce

By far the worst glue Iv ever used for corals. It’s very runny and when u put it in water it forms a seal over itself. It’s incredibly hard to break the “seal” and get it to bond with the rock. Even once you have managed to bond it to the rock work it can be easily removed. By far the worst I have ever used DO NOT BUY

I used this glue to rescape two tanks, an Evo 13.5 G and a 30G Waterbox. It was enough to glue the rockwork and the frags over three days in combination with a large size Tunze Instant Coral Gum. Only once did I have to cut the tip more and just a couple of toothpick pricks to keep the glue flowing between uses. It is thinner than IC glue, but that is helpful to flow into tight spaces once you get the hang of it. Very good deal. Works well with instant set spray also.

I glue my frags using a combination of this glue (cyanoacrylate) & 2 part epoxy. I put 1 drop of glue on the plug, then a 3mm ball of 2 part epoxy, then put a drop of glue on the epoxy ball. Then I squish my SPS frag on it, flattening the ball slightly with force. Works perfect every time. The epoxy molds to the form of the frag's skeleton and the plug and the glue forms the bond. The lid is higher quality than others I've used, sealing better.

gia detto sopra

Muy recomendable

I really like this glue for several reasons but it falls short in one critical area. This glue isn't very thick. It's more like regular super glue than gel super glue, so it tends to run when first applied. Once you have your coral/piece in the water it's fine. Other than that it has great hold, and the cap/tip doesn't clog like on other glues.