Coping Strips for Overlap Above Ground Pool Liners, Swimming Pool Plastic Liner Clips Replacement Patch Kit for 24ft Round, 15 X 30ft Oval and 16 X 24ft Oval (Qty 61, 15.74 inches Long)

We have a 30' x 15' Vogue oval above ground pool with a drop-in liner--see photo. We replaced the liner three years ago ---badly installed but that's another story---and we have had several feet of slippage of the liner on one side every year when we take the cover off in the spring ---I'm sorry I didn't get a photo of that. After doing quite a bit of research on possible solutions to our slippage problem, I found these clips and, although they're not specifically advertised for a drop in liner, I thought I'd take a chance and ordered them. We used a rubber mallet to secure them and they fit perfectly (see photo). We went completely around the pool top and have a couple of clips left. We feel that these clips will hold the liner and alleviate our problem but time will tell I guess.

Great item it did the job

Worked great on new pool liner install

Only issues is they slip a little on the corners so I’m always pushing them back up

Worked great snapped right on pool

Ita worked but I ordered a set of 2 but only received one and the other only had the wire no flame sensor

These worked great holding the pool liner in place. They were not bad to remove and put back on as we had to make adjustments pulling slack out of the liner.

Just what I needed for my liner. Even with the pool rails on my liner still slipped. I should have purchased these a long time ago.