4 Bay Hard Drive RAID Enclosure with Cooling Fan for 2.5/3.5" SATA HDD/SSD with USB A/C 3.0＋eSATA Cable, 3.5 Hard Drive Reader Supports 80TB Capacity, 8 RAID Modes, DAS(NO NAS)

I love this DAS! It was super easy to set up. The software needed to use the RAID looks a little dated but works fantastically. It took only a few minutes to install all four drives, download the software, and get it running. The software was very easy to figure out. If you’re looking for an affordable option that just works and works well, you should definitely consider picking this one up.

Works as advertised and setup was simple with the dip switch mapping to desired configuration. Purchased September 24 and Jan of 25 the cooling fan is already getting noisy. I might just disconnect the power to the fan as I'm running SSD's that really don't require cooling like spinning disks.

This review is for the raid-enabled version of the 4-bay enclosure.Installing 4 8TB WD blue drives went smoothly.The drives took a little bit of convincing to snap into the trays on one side, but they will fit just fine without any modifications.Bonus that full 3.5" hard drives are toolless, so that was a breeze.I used only the non-raid mode, and all four drives appeared over the Esata link to my PC (Esata cable included). Unfortunately, I can't speak to how well the raid modes work.I moved a large file to one of the drives and observed a sequential write speed of around 160MB/s. The same drive connected internally clocked 190MB/s. for many use cases this won't matter.I also had this connected to a PCI Esata card, so that could have been at play as well.I decided this enclosure wasn't for me due to the level of noise that comes from the fan. I wouldn't call it loud, but this was going in my living room and I am super picky about having it silent while watching movies. if I can hear it at all from 10 ft away, it's a no-go for me. My PC is way overbuilt for absolute silence, and I just can't expect that from, likely any external drive enclosure. If it were a bit quiter It might have worked for me.I'm not even knocking off a star because it is actually is a good value for a DAS and is fairly quiet, just not quiet enough for my use case.

The unit arrived and was set up within a only a bit of trouble. My drives fit in without the modifications listed on this Amazon page. It took some patience to fit the first drive. Once it was in, the drive was very secure. I suggest you work with the tray without modification to keep the toolless operation. Screws and a driver are included if needed.Once I got it running and visible on my computer I plugged it into the ESATA port on my NAS and it was immediately recognized. This gives me an additional 12TB of space. I am using reconditioned server drives, so redundancy is required.The main problems is the poor manual. It is very small making it hard to read the tiny font and diagrams. Take a photo of the page and read it on your phone.The instructions are insufficient for proper set up. The QR code on the back is labeled "software" but no software is required. Instead the QR code leads to instructions to complete the RAID setup. All that is required is a simple reset procedure but you have to know to do that.Once I did the reset, the device worked just fine.Contrary to the promotions on this Amazon page, is far too noisy to leave in an occupied room. The two inch fan is very loud. Fortunately I have a isolated server space where my NAS is located.Even though it is an attractive price, it far too loud to be not suitable for apartment use. DO NOT buy this for use in your family room for video streaming.

I bought this to access 3 hard drives from an old windows 10 computer to a new windows 11 desktop. I had already pulled the harddrives from the old computer. So, from the time the enclosure was delivered until i could see all three drives on the new computer was less than 10 minutes. The drives snapped in the trays and slid nicely into their slots. I didnt even need to use screws. I didn't do any RAID formatting (yet) just wanted access to the drives. It work perfectly.

El artículo incluye:Destornillador estándar.Tornillería para rieles.Cable USB B a C con adaptador tipo A.Cable eSATA.Fuente de alimentación compacta con su conector correspondiente.Todos los accesorios son nuevos y sin reparaciones; ofrecen una excelente relación calidad-precio.El inconveniente radica en la presencia de soldaduras frías en la placa base, lo cual podría ocasionar desconexiones o falsos contactos, comprometiendo la integridad de los datos. Contactaré a Amazon para solicitar una revisión. La placa presenta indicios de reparación previa. Si bien cuenta con una máscara UV para protección adicional, dada la naturaleza crítica de los datos manejados, no se justifica el riesgo de pérdida de información debido a un defecto de fabricación.

Super easy to mount drives! No hardware needed!At first I couldn’t figure out how to get the enclosure to switch to RAID mode (I’m using RAID5) but once I read the online instruction manual (the included instruction manual is very small and I couldn’t read it very well), and noticed the fact that the reset button needs to be depressed WHILE THE UNIT IS BEING POWERED UP, it worked perfectly!Meanwhile, I had sent an email to their support dept. and they got back to me with the same advice within about 12 hours. Pretty great, especially considering the great price!