Hon&Guan 100mm Bathroom Extractor Fan with Pull Cord Switch 4 Inch Kitchen Extractor Fan 14W 80m³/h Toilet Ventilation Exhaust Fan Wall and Ceiling Mounted

I bought this as an extractor fan for my shed, when I do painting to remove the fumes. Very effective. All I had to do was drill a 4" hole, screw the extractor to the wall and plug it in. On the outside of the shed I fitted a weatherproof louvre. The wall of my shed are relatively thin (about 60 mm) so I had to trim the outlet pipe of the extractor with a razor saw which was easy to do. It's not silent but I hardly notice the sound after a few minutes running. It is a basic model so you have to switch it on and off manually, it has no motion sensors or timer, but for my use that is fine. Very pleased, good value.

I bought four of these to force ventilation into a badly designed built-in wardrobe. The unit body is good quality plastic. Most importantly the wiring is actual copper wire and not aluminium coated like the previous fans I had ordered.Sound is subjective due to the way I have them fitted but they certainly aren't loud.

This fan features a well-thought-out design that leaves little room for complaints. While the quality of its components is average, its price is remarkably affordable and far exceeds expectations when compared to other products in the market. Additionally, it is easy to install, operates without any unnecessary noise, and performs its job efficiently.I installed this fan in the downstairs bathroom, replacing a much more expensive model that lasted only six years. Overall, it’s an inexpensive yet highly functional choice, and I hope it continues to work well for a long time. I will also update you on its performance after a few months of use.

For the price it's ok, looks ok, works ok but not sure it has the pull of the previous one it replaced plus the operating cord is only about six or seven inchs long and requires extending!

Easy to fit. Very quiet. Good value.

Think I mustn't have read the description properly. It comes with a cable fitted to the junction block in the fan and with a plug on the end of the cable. I obviously wanted to wire it directly into the electrical system, as anyone would. But no holes in the back plate to get cable through, not one. Could have drilled the plastic, but didn't fancy it. Returned the unit.

Put this in our in-house workshop to extract dust and its also where we ask our smoking guests to puff. The fan extracts well and takes all the smoke residue out effortlessly.

Muy bien todo