POWERTEC 4PK Toggle Clamp, 500 lbs Holding Capacity, 225D Quick Release Horizontal Clamps w/ Antislip Rubber Pressure Tip for Woodworking Jigs and Fixtures, Welding, Drill Press, Crosscut Sled (20326)

I started using a pocket hole jig to join structural members made from 1 inch pine and learned that the screws pull the joint out of place even when I use the clutch on my drill. Both pieces must be securely clamped. I built a jig using these thumb clamps that serves that purpose. There are heavier duty thumb clamps at higher prices from the same manufacturer but for pocket screwing pine, these are adequate and very reasonably priced. There are ways to "upgrade" these clamps with wing nuts and oversize rubber holders, but not necessary for what I do. The adjustment for thickness is a bit cumbersome so easier to get a bunch of these and use preset jigs for each thickness.

Yes good. Me love long time

Worked as planned

Great high quality clamps

Smooth, strong clamping. They function well.

Does the job for my woodshop jigs.

Packaged well and work as expected.

Works ok. Made a ripping jig for my table saw using these. Kind of a pain to adjust the set screw after every board I rip.