DeWalt DEWALT DE6292 Guide Rail Joining Kit, Blue

These things are essential if you use the rail system. The way the saws work, you need the best part of a 24cm run in and 12cm run out out of the material so that the saw is guided as accurately as possible. That means you need a rail that is about 36cm longer than whatever you are cutting. The largest rail DeWalt makes is 2.6m and with the lead in and out, it will cut about 2.2m. You need this joint and an additional 30cm or so of for 2.4m sheets. I have a 2.6m rail, a 1.5m rail and a 1.5m rail that I cut in two with a mitre saw to make a 1m rail and a 0.5m rail. I am covered for just about everything!! I bought the 2.6m before I realised that it's not long enough for 2.4m sheeting.Another oddity is that you require a 3mm hex key to tighten the adapter up, but one isn't provided.When the bar arrives, first thing you must do is check it is absolutely straight. Because of the way they work, they just aren't going to work if they are even slightly bent.Recommended but expensive for what they are.

Expensive for what it is but it work fine.

Dies what it is supposed to do

Very good company

Very good

ok

I was, unfortunately, forced to purchase this to join two sections of guide rail together. I do not understand why this is not included with the guide rails like it with most other systems and why it is so expensive for a piece of bar with a couple of tightening screws. Really disappointed with DeWalt over this rip off product and pricing.

for what it is its expensive it should come with the guide rails, they do take some time when putting two together to make sure yu have them lined up