FivePears Up Cut and Down Cut Spiral Router Bit Set with Extreme Life Coated, 1/8" Cutting Diameter, 1" Cutting Length, 1/4 inch Shank CNC Carbide End Mill for Wood Carving Engraving Grinding Grooving

The media could not be loaded.  The 5 pears UCC 28410 manhandled this 3/4" cast acrylic Luke a hot knife through butter. This being my first 5 pears bit I have used let me tell you Amana better watch out. I used conservative speeds and feeds which they actually send with their bits but did not have any for cast acrylic. I was able to ramp it up during the machining to give me a good baseline for acrylic in the future. I WILL BE LOOKING TO 5 PEARS FOR ALL MY CNC BIT NEEDS. Side note... when the process was done... bit wasn't even warm.. If I could give them 10 stars, they would get it!

I have not used product yet. Well protected in shipment arrived earlier than expected. Looks like a great product. As a set with one of each; uncut bit and downcut bit.

These lasted less than 60 seconds. Running in 3/4 MDF 85 ipm 1/8” doc 12,000rpm. Their non coated compression bits last 1000x longer. Three stars because it may be me but I kinda doubt it.

The media could not be loaded.  So far the best 1/8 bit I've owned. And it's sturdy. At .125 depth cut I achieved speeds of 700mm/min. But currently running it at 500mm/minWill definitely buy again

This thing is loud as heck, just watch yourself turning it on, it sounds like a dolphin being sodimized. Don't ask me how I know what that sounds like 🐬 🤭

I used this to cut 18mm Sande plywood on a Shopbot CNC machine. Worked great. Extra long compared to many 1/8" bits that can only cut 1/2" deep.

A few dollars more but good quality. Worked fine in very hard wood.

As the title said it lasted around 30 minutes and it broke, I have dollar tree quality bits and they last longer AND don’t forget the price like seriously I used it for wood thinking the price would be worth it but nope it just snapped as you can see in the picture