ABS IP67 Waterproof Dustproof Electrical Junction Box, with 15A 600V Barrier Terminal Cable Connector, 3 in/3 Out Power Junction Box（3.93 * 2.67 * 1.96in）

Great little box , made the job easier. Tight but easier. The water proof seals worked great around the wires. No trouble. Nice box , still plastic so be careful

Well, it works as stated.

Good

This box did a great job . I used it to repair thermostat wire on outside air unit . This got cut by a weed eater and was going to be costly to repair . I just got this now wired cold of wire to the same . Everything worked out great ..

Simple box that does exactly what it should.

it's a black box with fittings

I was really excited about using this. I recently installed a gate opener, and the connection for the second gate had five wires that needed to be spliced. One set of wired was stranded wire, and the other set was solid wire. So, this seemed like the best solution. I got this even though it had two extra connections, but I figured, who knows? I'd rather have extra than not enough. Well, to me, the box is too small for so many connections. I tried connecting them with the panel outside the box, because there was a lot more room for fingers and screwdrivers. But once I did that, I couldn't really get the connected board into the box because it was just too big. So, I figured I'd have to undo the connections on one side and just do those while it was already set in the box, so I undid one half and attached the bar to the box, but I still could not get all the connections made inside the box because I ran out of room. Then I figured I would need to undo the connections again, cut the cable back a bit so I would have more slack in the wires. That's when I discovered that when I'd screwed the panel into the box I'd messed up one of the screws, and it was stuck and in trying to get the panel back out it just snapped in two pieces. I considered getting another one because I had a good idea of everything that I needed to do before trying to attach the wires. But I didn't want to spend more money only to find out that it still wouldn't fit right, and this was only using 5 wires rather than the 7 it was made for. So, I bought some of the individual snap connectors and that took me about 30 seconds to make the connections. Then I just bought a cover for it and voila. So, I was not impressed. But I gave it three stars since I'm sure part of it was my inexperience with wiring.

Installed in my golf cart lithium upgrade, fit perfect where I needed it and great seal from the elements.

Muy util para conexiones de cables no de gran calibre y muy practicos

just what i wanted