5mm WALL PANEL & CEILING PANEL WHITE WITH 2 SILVER STRIP ATTACHED Tongue and Grooved Ideal for your bath/shower walls going over tiles and on your ceiling 100% waterproof

My bathroom was transformed with this cladding. It’s so easy to install, looks fresh and easy to clean. It’s also great value for money and I would highly recommend.

Used for wall/ corner of downstairs toilet. Value for money covered uneven tatty walls. Looks amazing!

As a rot free water resistant ceiling coating for a shower room this cost is hard to beat BUT I wouldn't say they're hard wearing enough for a wall unless you don't have kids. The outer shiny surface is brittle and extremely thin, it's about same thickness as decent tinfoil but plastic not metal and it does chip dent and split along the ribs very easily. A sharp snap off blade utility knife is better than a Stanley as any sawing action it likely to hit the edge of the cut, chipping it. The ribs and back surface are much tougher as they are thicker and the boards are fairly stiff, so you can hold the middle and let the ends droop without worrying about it snapping. The boards cut very well without chipping with a festool type rail saw or mitre saw but making a good job on downlight holes is tricky as a toothed hole saw can tear the surface so it's best to use a knife, even then the edges dent so be patient. A hot knife may work well but I didn't try it. Polymer sealants stick it up no problem without screws, they are very light panels. These panels cannot be joined end to end very well as the tounge and groove is only on the sides so get the longer ones of you have a bigger room. You may be able to put square joining rods in between the ribs to do this but I think the top surface would crack. Open areas are a doddle and they can be thrown up very quickly and the joints have a fairly good angular allowance so fitting the last one up against the wall leaves very little gap, but remember expansion gaps anyway or they will creak when they get warm. I put a smear of sealant along the joints to make them waterproof as water will get behind them otherwise. At the end of the day there is nothing else I found better in a similar price range but the exterior cladding materials are far more substantial but matt and the professional quality internal ones are five times the cost.

It's convenient to work, very easy and beautiful afterwards.

Very thin and light easy to cut and install but fragile if dropped on handled badly.

Looks great when up, but quite hard to work with, in particular cutting for the fiddly bits as it is so brittle. IE you have to be very careful not to apply any pressure to the panel as it cracks easily.

Good quality product, good adhesive & easy to install, good value for money.

Easy to fit and delivery was quicker than expected!!! Slight damage to end of some strips but thankfully didn’t need full length. Would highly recommend gives a new modern look to the room!