XPELClear Paint Protection Film Roll - 6" x 84" Polyurethane Wrap for Ultimate Protection Against Chips, Scratches, and Road Debris - Perfect for Cars, Trucks, Motorcycles, Bicycles, Boats & More

Easy application, no issues. Adhesion was amazing. Applicator (sponge) worked perfectly.

I bought the XPEL Paint Protection Film to shield my shiny new truck from the daily onslaught of road debris, scratches, and dings. Application was straightforward, and the film is practically invisible once installed. It does an amazing job protecting against rock chips and keeps my paint looking factory fresh.But, as I recently discovered, it won’t save you from Mother Nature’s wrath. A hailstorm rolled through last week, and while my paint is still pristine, my truck now looks like a golf ball. Lesson learned: XPEL doesn’t claim to make your vehicle bulletproof—or hail-proof, for that matter.All jokes aside, this product is fantastic for its intended purpose. Just don’t expect it to be your truck’s superhero in a weather apocalypse. Highly recommend for keeping everyday wear and tear at bay!

Works on headlights ok. Will conform and stretch as needed for contoured headlights, but, still had 2 or 3 small bubbles that appeared even when I started in the center with the enclosed rubber spreader and worked toward the outside of the headlight. Used distilled water and a tad amount of liquid dish soap and along the edges as needed to help the film stick better I used iso alcohol and water. Overall the headlights look pretty good. Use caution if you partially peel up the film after you squeegee it down for that can leave a visible line showing in the film. Just trying to minimize the typical crazing and hazing you get as headlights age. I polished the headlights like new so time will tell if this film helps maintain clarity or not?

High quality product. The included squeegee works great.

Used for Bronco fenders. Just be careful when getting hand washed it bubbled up some from the washers.

Not sure why people are saying it’s very hard to install, surprisingly for me, it was one of the most easy installations I’ve done. I didn’t use it for large areas, just used patches on dings in the clear coat or paint to stop water from getting under clear coat and to ensure that the dings didn’t progress. Pretty much invisible, unless you look very hard. Make sure you cut your sizes liberally, and clean the application area thoroughly with isopropyl alcohol. Then make sure you spray lots of soap water on the application surface and the adhesive part. It helps to spray the adhesive side when you start peeling it off the paper. Give it another few sprays so the squeegee can move across it easily. So far, 10/10. Will update as the film ages.

Best PPF for the money! Be patient and follow directions for prepping surface and “slicking” the film.

It's not the new PPF tech which it's much more flexible and easy to install on curved modern headlights.