Will it last for a neon 12" clock? They all want to burn out after 6 months.

I don’t know. I use it for fractal burning

Does this transformer have the secondary ground fault interrupter? If so, do you need to disable it before doing wood burning?

It has a ground wire but beyond that there appears to be nothing else and there is no other information available or any way to tell.

where can I find information on how to set this up?

Steps 1, Crimp 2 terminals with pliers or crimper, connect the 2 terminals to the 2 clamps. The 2 output cables no positive or negative. 2, Mix 5g baking soda with 150g water, put a rubber or wood sheet on the table as an insulator for electrical and heat. Leave the neon power supply’s ground yellow-green cable alone. 3, Wear electrical insulated gloves, brush some baking soda water on the wood surface, not too wet, not too dry, put the two probes on the woods, then connect the power, press the foot switch, press the rocker switch, wait for several second or minutes to burn. 4, After burning a while, the wood surface will be dry, please shut the power, then brush some soda water and begin another burn. Notes 1, Do not touch the 2 probes each other, when connceting power. 2, If you do not use electrical insulated gloves and foot switch, you must shut off the power before brushing water, moving probes and other dangerous actions. 3, We sell clamps,brush,foot switch, insulated gloves and copper rods for lichtenberg wood burn on usa amazon.

Current Rating	0.9 Amps
Minimum Frequency	50 Hz
Mounting Type	Put on insulated wood or rubber for lichtenberg
Power Source	Corded Electric

Lichtenberg Machine 10kV 30mA Neon Sign Transformer Fractal Wood Burning Machine Burner Device Neon Power Supply for Real Glass Neon Not Led High Voltage 10000V

التفاصيل

الوصف

المواصفات

الأسئلة الشائعة