I need a longer piece of webbing. Can I remove the webbing and replace it with my own 1" wide webbing?

I'm 850 miles away from mine but I think I remember them being molded, so I think not-You might try just forcing your webbing through a piece of garden hose, doubling the contact point and sending a hot nail through both pieces for the screw-good luck!

Will they fit and support Ocean Kayak Big Game?

If yours has web-strap handles on it now then they should be a "mostly" direct replacement. The screw/rivet locations need to be drilled out by placing the old handles over the replacements to mark location. Otherwise, they are the same design and should support the kayak as the originals did. I just replaced my torn handles on my OK Prowler 13 with these and they fit perfectly. It appears, from pictures of the original Big Game, the same handles were used across the product line so it should fit similarly.

How much weight can one handle withstand?

I installed them on my sit inside wilderness system kayaks with reinforce stainless steel plates inside since I could reach that far just to help with weight. The kayaks weighs between 45 to 60lbs ... they have held up so far. Never had an issue.... you can also use washers then put the nut on after to help support weight. If your going to use these on a sit on top I would recommend washers or a plate if you can reach the area as they are a lot heavier.

Size	11 inches x 1 inch
Material	Nylon, Rubber
Brand	H2o Kayaks
Vehicle Service Type	Watercraft
Load Capacity	300 Pounds
Fastener Material	Stainless Steel
Fastener Type	Screw" or "Bolt
Number of Pieces	2
Product Dimensions	11"L x 1"W
Manufacturer	H2o Kayaks
Unit Count	2.0 Count
UPC	700621268628
Item Package Dimensions L x W x H	6.65 x 3.15 x 1.5 inches
Package Weight	0.16 Kilograms
Item Dimensions LxWxH	11 x 1 x 0.04 inches
Brand Name	H2o Kayaks
Part Number	JY-B1101-1

H2o Kayaks

التفاصيل

الوصف

المواصفات

لديك سؤال؟ انظر ماذا طلب الآخرون

الأسئلة الشائعة