ID-COOLING SE-214-XT ARGB WHITE CPU Cooler 4 Heatpipes CPU Air Cooler Addressable RGB Light Sync with Motherboard(5V 3-PIN Connector) CPU Fan for Intel/AMD, LGA 1700 Compatible

A very good value cooler; it keeps my CPU much cooler compared to my previous one. Cooling my AMD Ryzen 5 5600 to around 38°c-45°c at idle depending on the room temperature. The installation of the heatsink was simple, but fan was rather annoying to clip on using the supplied metal clips; though it worked out in the end. The fan is very quiet even at higher loads, but that is compared to my previous one which is basically a jet engine at higher loads. The Fan has RGB but since my b450 Tomahawk Max motherboard has no place to connect it, I unfortunately can't use the it and can only use the fan as a normal fan without lights; Otherwise it works perfectly. Time will tell how long the fan lasts, but any regular120mm PWM fan is probably compatible (you just clip it on with the metal clips onto the heat sink). Overall, a very good cooler that does the job well and doesn't break the bank.

Perfect as described and keeps my ryzen 5 7600 as cool as 55 degrees fits perfectly is great value for my new and the quality is next level. Overall a very good and functional purchase

I've been using the ID-COOLING SE-214-XT ARGB WHITE CPU Cooler for a few weeks now, and it's been fantastic. The installation was straightforward, and it's compatible with my LGA 1700 setup. The cooling performance is top-notch, keeping my CPU temperatures low even during intense gaming sessions. The addressable RGB lighting adds a beautiful touch to my build, easily syncing with my motherboard. Overall, this cooler offers excellent value for the price and enhances both the performance and aesthetics of my PC. Highly recommended!

Usually not a fan of RGB, but the lights are fine and look good inside of my case. It also acts as a bit of reassurance that it turns on when I boot up my PC.I bought this fan because it was cheaper and will just work with my CPU, MoBo configuration. Installation was easy, just follow the instructions on the manual. The screws did initially give me a bit of trouble. This was my first time building a PC so I was nervous if I was doing something wrong, but what you need to do is apply more pressure down on the screws to make sure that they go into the holes on both sides (make sure that you so them evenly) as they are spring-loaded.Temps on my CPU I have no complaints. My Ryzen 7 5700x stays very cool on idle and doesn't get hot when gaming.Noise levels is hardly noticeable, even when sitting right next to it.Only real complaint I'll give with the installation is how fiddly it is installing the fan onto the heatsink. Idk how it is with other coolers of a similar form factor, but it something that I found stressful as a first time builder.

Easy to install although I did watch an install video as a sense check as the instructions are a bit too sparse and eye-strain small. In terms of sound it's maybe slightly louder than the Wraith Stealth it replaced, but still very good for having two 120mm fans instead of one 85mm. They are only running at about half speed at most.Performance-wise it has reduced a Ryzen 7600 idle temperatures from ~55-60c to ~35-40c, and gaming load from a toasty ~85-95c to ~45-60c. So about a 20-30c improvement for £20, with plenty of fan speed headroom for more, which seems to be a bargain.Overall a good value purchase and I doubt I'd see much better cooling even if I spent a lot more. Should be future-proofed for higher wattage CPUs as well.

my fan on my two pipe low profile 65w cooler was going too fast making too much noise specially in this heatwave so I wanted to upgrade to something a little bigger.I was skeptical before buying due to really having no idea how much this would help based on reviews but it worked out and this review I am writing is the one I wanted!took a R5 5600 moderate idling few apps open from around 50 - 65C down to around 35C, on a fresh boot its even under 30C for a short whilemoderate gaming went from around 85C to around 45Cplastics of the fan feel a little cheap but the blades feel good and it isn't making a sound! overall quality feels really good, have not tried any super intensive loads for long duration's but given the performance I am seeing so far I am very happy and confident temps will hold.update : one issue I will note is the RBG of the fan is a bit wonky, from UEFI it would only set the fan to green no matter what combination of rbg I set, unless I set random, from an app in the OS seems like sending green was making the fan red and setting it red was making it green but at least the app would let me set whatever colors I wanted like solid white, ended up setting it to rainbowHighly recommended cooler for a R5 5600 and the price point is great

For the price it is a great cooler. Bought it as a cheap cooler for a pc I built for a family member and it performed as well as my £100+ aio in my PC with similar components.

Bought this to replace my AMD stock cooler to see if i could reduce noise and temps. The tower is easy to mount and includes a nice accessory package and clear instructions for many sockets. It does not include thermal paste.The included ID Cooling XF-120 fan is quite noisy, unfortunately.It was louder than the AMD Wraith Stealth but does have a more pleasant and less whiney (more neutral) sound to it, so still a slight improvement IMO, but I swapped in a Noctua NF-P12 Redux I had around for a different project, and it is night and day silent.My 5600X can run at full bore without breaking ~65C with this and more aggresive fan curve, happy with the temps for sure!Thumbs up on the heatsink and mounting though :)