S2000 Ready-to-Use Sodium Silicate Concrete Sealer Densifier and Surface Hardener 16 OZ Sample

Applied per instructions. Product is superb. The product lays down perfectly. Two this coats were applied. Without hesitation I would buy again. I am planning to using Armor products for all our concrete applications. Finally, someone makes these products in one gallon containers!! Kudo to the Armor folks! I’m sick of only buying five gallon containers.

This stuff works great. My garage floor is concrete. It didn't cure properly and is eroding. There was always a layer of dust on the surface. I tried rinsing it with water but once it dried it started eroding again. This product claimed it would harden the concrete and eliminate the dusting. It did exactly that. There was no more dusting and the concrete was shining. I aplied it with a garden sprayer.

Easy application with foam paint brush roller. It does leave a slight wet look as shown in the photo. This does not bother me but may not be desirable to others. I plan to use their sealant next.

Seals deeply and strengthens as well as protects your concrete. This product is great for garage floors because it seals them permanently against oil, salt, and other concrete damaging agents. It applies easily with a sprayer after mixing with hot water. This is NOT a cosmetic surface sealing agent, it penetrates up to 4" deep binding to any calcium and silicates to reduce water absorption up to 98%, giving high resistance to efflorescence, yielding a 45% increase in compressive strength, a 45 % increase in surface hardness, and finally, a >200% increase in wear resistance! We sealed our 1350 sq foot concrete slab barn floor with 1 gallon of Foundation Armor S2000 mixed with 3 gallons of hot water, using a garden sprayer and a long handled brush to spread any puddled or over-sprayed areas.

I thought I was getting a dilutable product that would make 4 gallons. What I recived was one gallon undilutable which was not enough to do my project. I have foung another product that will work. They also have the same picture indicating 4 gallons on Home Depot's page so I don't think this is a complete accident.

This is my second time using the product. In both cases the before and after are the same story. Before we had signs of efflorescence and concrete shedding from basement walls. The product is easy to apply with a spray and goes on evenly. After it dried the shedding was gone. Three years later and no occurrence of efflorescene and no more shedding. Just applied it at another location and expecting the same results there,

I wish I had a picture of my 1000sqft floor before I applied this product because I'd sue them. I grinded my floor (spent thousands with grinder rental) and it looked gorgeous, ready for a densifier. Followed the instructions. This product destroyed my floor.

I used it to harden some concrete furniture that I'm making, and it really makes a difference. I polished up to 200 grit, applied the product with a brush following the dilution rate and waited to be dry. I then went on and polished the concrete up to 3000 grit (the concrete in the video was polished to 1500 grit) and I could see my reflection in the concrete. I have a second piece of furniture made out of the same mix, I tried to polish that without applying the hardener and I could really see and feel the difference. If you are looking to get a great finish on your concrete, invest the money and time to apply this product, it will really make a difference in the final look.