Get the organization of the pws4105tx 41" deluxe extreme portable workstation with the mobility of the pws4124rctx 41” roller cabinet in one great Combo! deluxe pws: 41.5” w x 23.625” D x 23.25” H •16 gauge steel construction with Welded seams •power tool Rack with built-in power strip •pull-out side shelf and side drawer with built-in power strip •drawers and shelf use ball-bearing slides rated 100lbs/pair •storage Trays built into drawer fronts •weather stripping creates seal against dust/moisture includes: • 23 combination wrench Pegs • 49 screwdriver/ratchet driver/extension holders • (48) 1/4” deep/shallow socket Pegs • (32) 3/8” deep/shallow metric socket Pegs • (22) 3/8” deep/shallow SAE socket Pegs • (32) 1/2” deep/shallow socket Pegs • (22) specialty tool socket Pegs • (13) wide specialty tool slots • 29 piece drill bit holder • 6 slot pliers Rack • roller cabinet: 41-1/2”w x 24”d x 41-1/2”h • self-latching, full-width aluminum drawer pulls • drawers use ball bearing slides rated 100lbs/set of slides • EVA foam drawer liners included
D**O
So far so good. Love the slanted top section.
So far so good. I bought this (the whole upper and lower unit) about 6 months ago I think. I haven't rolled it around much yet, but i already have a lot of tools in it (just about all the tools I own). I love the organization of it. I bought this box specifically because this is the only toolbox I've seen with the slanted upper and that's exactly what i wanted. Montezuma has one too, but I honestly think this is the Montezuma just rebranded. I don't have the ridiculous amount of money for Mac, Matco or Snap-On, but this one seems pretty well built. I read reviews on it before purchasing it and one person said they were rolling and it wasn't nearly loaded to the capacity it says it can hold and the caster/wheel bashed in a bit on the bottom and now it's at a bad lean. Because I read that, I still ordered the tool box but I bought some 1/4" thick cold rolled steel plate (4" wide) and cut two pieces to the length of the width of the box itself. I drilled holes in the plates so the caster bolts could go through and mounted these two plates wide-ways between the casters and the bottom of the box. I really feel like this buckling issue the other guy experienced will not happen to me, lol. Otherwise this seems like it will continue to be a very nice toolbox. The drawers slide well on the bearings and I like the autolocking feature of each individual drawer. You just lift the handle as you pull the drawer out, and when you close it, you hear it latch again.
ترست بايلوت
منذ 5 أيام
منذ شهر
