eSUN eBOX Lite Upgraded Dryer Box of 3D Printer Filament, Dehydrator of Filament Storage Box, Keep Filament Dry During 3D Printing, Spool Holder, Compatible with 1.75mm, 2.85mm, 3.00mm Filament

Since first starting 3D Printing some years ago, someone said "use eSun PLA+".. So i did. It works. I've never used anything other than this (and any freebies that came with 3d Printers). It's worked perfectly in my ender and bambulab printers.I have had a few moisture problems, however I don't dry my filament, and I keep spools of it hanging around for years. Normally just cut the gear word section off and carry on.Amazoin being able to deliver next day is perfect, and I expect their stock is turnbing over quickly, so always had 'fresh' filament.

(Update)eSUN reached out to me about my review and the problems i had with the pure white filament. They sent me a replacement spool. So i have updated my review. It was great for them to be so proactive.OriginalI have used gone thought 3 rolls of this without issue, but the Pure white is Garbage. It keeps getting stuck on the spool. I have never had an issue with Filament, this one just will not let me complete a print with it getting hung up on the spool.All the other filaments are great.

Very good filament out of the 50 I have bought only had one bad batch (moisture in the filament) which I returned and had the credited back on my account with in 4 hours which is good so reordered, fingers crossed

Yep this works fine. Would have been 5 stars but the vacuum pump is quite a slow way to get air out of the bag. I ended up leaving a small section of the ziplok open and sucking the air out with my mouth which only takes a few seconds, and then zip up and finish off with the pump, job done. Complete with some sachets of silica gel, the kit contains everything you'll need to keep up to 10 reels of filament nice and dry for a long time, they even include extra vacuum seals and of course you can buy dessicant anywhere if you're worried that its effectiveness might be fading with time (or dry it out in the oven to regenerate it)

This is the first brand i have tried PLA+. I am very impressed with it. The print quality is great, i do however get very fine whispers of filament when the print head moves across the print, These are however easily removed.I will continue to this brand as i am very happy with the results.

Filament twisted and knotted straight out of the packet had to re-spall it.

Really liking this bone colour pla.Pla is accurate as described 1.75. Found it optimal to print at 220c with speed of 120ms, prints perfect at these settingsFilament packaging was okay just could of been a bit better because vacuum bag was a bit lose with some air left inside so i made sure i dried this pla for 24h at 50c before printing and 1st print came out perfect without any blobs or any other artifacts from wet filamentGreat value for this great quality pla+Test model printed on ender 5s1

I’ve had some good results with this PLA+ and have been buying different colours. No problem with bed adhesion printing at 210C with bed temp at 50C.