JMT Mini Multi-Rotor 1806 2400KV CW CCW Brushless Motor for DIY 2-3S 250 Mini Drone FPV CC3D 260 330 RC Quadcopter (2CW+2CCW+4ESC)

3s burned 2 ESC out. Keep the ESCs in an air stream for cooling. Check ESCs before soldering on tips …

Decent product at best. .bought this set 2 weeks ago for a 250 fpv quad I designed. .brand new parts throughout, 3s pack, triblade props, ect. .3 of the 4 esc already smoked out and burned. I calibrated them to my spectrum radio/naza m setup first. .also 2 of the motors smoked out and are no longer with us. .total flight time, less that 10 mins total. I definitely will not buy this set again. .oh, and the motors were shipped correctly. The esc I got are not JT esc's, they are 'RED Hobby' which I've never even heard of. .3 esc and 2 motors down, with no shorts or load issues. .pisses me off I wasted the money. . .don't waste yours

I soldered up two of the four motors and ESCs. (That takes about an hour.) Neither ESC provides the specified current of 1 A. After a few seconds of operating the servos, the motor is commanded to quit.DO NOT BUY

Its a good motor for a table fan but not enough power for a Quadcopter and the mounting hole are not related to the specs off the motor if the change the mounting hole to like a 9v9 and.12v12 will be great for a 2s freestyle drone but , oh well " good motor no enough power for the size build "

I could not get the Esc's to flash for the life of me. I think you need to solder on to the board but to be honest im not sure since there is no documentation. Motors dont have much power but are fast. Ill be returning these since the ESC's just dont work.