Cal Hawk Tools CZCW45B-50PK-1 4-1/2" Metal Cut-Off Wheel, 50 Pack

These work as good as any cut-off wheels I've used. I like the 1/16" thickness, it cuts through metal fast and doesn't waste a lot. It's also a sturdy enough wheel that you don't have to worry too much about it breaking. But, it is thin, so you don't use it properly, it will break.Most of the time, the paper label disintegrates with no issues, but I did have one that bound up when I was cutting through 1 inch square tubing. I stopped, removed the label and it was fine, but I wanted to mention that, I've never had a grinding wheel label cause me any trouble up to that point.You will save a ton by buying these in the 50 pack. I highly recommend these cut-off wheels.

This is the best bang for my buck i could find in person at a retail store, or anywhere else on the internet.Normally, these are about $2 a piece anywhere you go, and i'm a scrapper, so i cut a lot of metal with these, and the cost adds up.These cost less than a buck each, and i dont feel bad about using them as needed because i seem to always have more.The solid wafer construction is comparable to any other brand you might find. They are of absolute equal value to any of the ones i have ever bough. just make sure you know what you're doing with a cut-off tool

Sure, the cost is awesome. But each disc in my package of 50, has major rust on the arbor. So it is difficult to install and remove these discs from my angle grinder.I used these cutoff discs on both my Dewalt and my Porter Cable anger grinders. Both had difficulty in installing and removing these discs. What I would do is use a round file to remove the rust from the center arbor of these discs before installation. The worst part of the rust on the arbor hole, is when you need to swap this disc for another one, you may end up damaging or breaking the disc upon removal!I went thru about 20-30 of these discs so far.

These discs cut nicely and considering what they do for me they last fairly well. This is the second time I've bought them, so I must like them enough to buy again.

I used one of these disks for the first time yesterday and cut 1/4 inch steel plate to make a mower bracket. I made a total of about 12 inches of cut in the plate and still have over 3/4 of the disk remaining. They hold up well and cut very good. I've used all of the expensive brands in the past and I can't see any difference in the quality so far.

When first order quantity was exhausted, I promptly ordered more!

I ordered the cut-off wheels on Monday around noon. They arrived in the evening USPS mail at about 4PM on Wednesday. They are of a good quality. They seem to last a bit longer than the last set that I purchased from a discount "freight" company.

These are the best cutting disc I have found they go 2-3 times farther than name brand disc for a fraction of the cost. Another positive they don’t blow up as easy as the others I’ve tried. Only negative they don’t grind as good on surface because there backing on both sides but that’s what makes them better for what they intended use.