KBS Coatings 65402 Jet Black Xtreme Temperature Coating - 1 Quart, 32 Fl Oz (Pack of 1)

Works good, I just tried it on a pair of cast manifolds right before a show . Very nice color I'll buy some more for my next project.

Super easy to apply. Great finish and the color was spot on.

Purchased a 2024 ranger extremely nice looking truck one thing that bothered me exhaust system look like an after thought gray in color ! Clean exhaust pipe really well rinsed let dry apply to tight coats eight hours in between coats and then two medium coats cure for 24 hours and then ran for 20 minutes. Two weeks later looks perfect ! Take your time prep it right starting on a Friday. Finish it on Sunday.

I used this product to paint the rusty looking center hub area of my brake rotors. I did not like the requirement that you have to let it sit for eight hours in between coats, but the finished product looks great! So far it’s held up nicely, we will see how it stands up the test of time. For anyone who’s wondering, I just brushed it on. The excess was easily cleaned off the face of the rotors with some brake cleaner and a rag while it was still wet. I did not bake the stuff in the oven like the directions called for. I figured just driving the vehicle would put some heat in the rotors over time. So far so good.

My headers have been on the engine for over 30 years and really needed a touch up. I did not want to use spray because of the potential mess. Finally, I found an alternative that could be applied with a brush. The paint goes on really easy and only needed one coat.

This product performs exactly as it states. I used this product on my hot water baseboards (yes- baseboard heat covers) and it covered all the old rust immediately. Dried incredibly fast and is seriously scuff and chip resistant once dried. Note: You need to work in a well-ventilated area and wear proper protection because the vapors are strong. Read the can it will provide all the safety info. I wish I used this type of product years ago, it would have saved me a lot of time and money. I love the results.

The coverage was great on my fire pit. This stuff is durable! Great product.

Just as title says GREAT COLOR, Sprays Decent, but is a little bit Pricey, id like to see under $20... Haven't tried on high temperature headers, engine Valve Covers or anything of that nature yet. But plan on it in the future! Will be using the Xtreme 65100 Gray Primer I also Purchased first before spraying on this if I do spray an exhaust manifold/header/Turbo Manifold etc... Im not sure if needed but I also picked up some of VHT Flame Satin Clear and Rust-Oleum 2000° Clear and Rust-Oleum 2000° Primer to try with this... Directions say to bake the primer at 550° for 60 minutes then again for 30 minutes to cure it before painting over it or anything, but the high heat of just running on the vehicle will bake it and cure it in 3 running operating cycles of 1hr drive and 30 minute drive and another 20-30 minute drive. Then can pull off to paint using this Xtreme charcoal paint (you could mask off engine bay and paint them while installed but its impossible to get to the backside of the exhaust manifold (engine side) as the engine itself os typically in the way, so therefore I just recommend to remove the manifold to paint and cure in a baking oven, or just place inside of a grill... If you dont wanna do these necessary steps at least fir the primer~to~paint stage, then i recommend just going with a bronze~gold, or Black Exhaust Wrap to help solve any high engine bay temps etc...