Batmax 2Pc LIP1359 Battery Replacement for Sony PS3 PlayStation 3 Controller Sixaxis Dualshock 3 CECHZC2E CECHZC2U

The controllers would not hold a charge and these batteries work well. The process was not complicated and the screwdriver fit perfectly. There are no instructions. If you need a visual, check youtube.

Works as intended and was relatively easy to install

My PS3 controllers batteries were dead and order the Batmax kit. The first controller I worked on the buttons fell off. Second controller I used freezer tape to hold the buttons in place. I tried a flat head screw driver to disconnect the battery and that was not working. A pair of needle nose pliers worked fine. Batteries fit prefect so no complaints.

batterys were easy to install and have better life than original and nice little screwdriver and cable

Bought these replacement batteries for my PS3 controllers. Installation was easy and the kit comes with everything you need!First, I used the screw driver to remove the 5 screws on back controller plate. Then the pry tool to separate the controller plates. Once opened the original battery was easy to disconnect and replace with the new battery. It Fit perfectly. Put everything back together in reverse order and boom my controller works like new again.The one thing I will say when put the controller plates back together again make sure you reseat the R1 R2 and L1 L2 buttons before you put the plates together and always check to make sure the buttons function as they should. If they don't, take the back plate off again, reseat the buttons and try again. It's super easy to get it right don't worry.Been through one power cycle so far and I'm very happy with my purchase. I recommend these replacement batteries to anyone looking to salvage their PS3 controllers!

I bought these a while back ago. Worked great for a while until I noticed my controller shell expanded. I opened it up to find the battery was swelled. Even though it still worked and tried to charge. Avoid this fire hazard. I got lucky I noticed it in time before it exploded and got on fire.

These were fairly straightforward to replace, but keep in mind that you might have one of three different styles of Dualshock. Two of mine were the same battery as this replacement and was a perfect fit, but two others required some finagling to get to not give me pause that the battery would be rubbing on the circuit board.However, I just stuck on a few small squares of squishy rubber "non slip" padding that I had around on the battery facing the circuit board and it went perfect.You'll know if I recommend this for the controller you have if you open it up and the battery has tabs that connect to the circuit board. Just search foam non slip pad and you'll find the right stuff. Pay attention to the solder points on the circuit board and you'll know where to put the 1/4 inch squares you cut from the pad to keep it away from the metal points.They check out as close to the stated capacity, mine tested at 1688, 1750 mAh, which is 94-97%.Definitely worth it if you love your PS3. BUT grab some q tips and cotton with some rubbing alcohol for when you take your controllers apart, you'll want to clean the seams lol.

May have longer life than original... Worked perfectly but does not have the tabs that match older PS3 controllers. Some controllers had batteries with tabs on them that hold them away from the control board, these do not. These work perfectly for the ones with the adhesive pad to protect rattling against the board. but by adding one of those pads to these solves the problem for all styles.