Partsam 2pcs 3/4" Smoked Amber LED Clearance Light Side Marker Light w/Rubber Grommet, Grill Lights Turn Signals For Truck Trailer Pickups RV, 12V, FLush Mount

These little lights are perfect. They output a good about of light even though they are smoked, but you will need a resistor in line to stop them from "fast blinking" if you use them as turn signals. Easy fix even if you are not electrically Inclined. Great when you are wanting to hide lighting on a bumper for a more clean look.

Love them, they look absolutely amazing and work like a charm. Though you’re probably likely to get hyper flashing, I think it’s called. They’re super easy to install, you would need a 5/8ths drill bit to fit them in place. It’s more of a yellowish color when turned on. Make sure to remember that white is negative and black positive, for whatever reason

Used in my 2017jku side marker lights and they are very good quality and very bright

I mounted these lights to my 2004 Jeep Wrangler Rubicon. I broke a plastic fender flare playing in the woods so I decided I liked the way the Jeep looked without the flares. Instead of cutting the side turn signal lights, I replaced them with these little guys. I did have to drill out one of the factory holes a little wider with a step bit, but that was pretty easy. The smoked look looks a lot better than an amber colored light. But when the lights are activated they provide a somewhat bright amber color. Good enough light during the day and night to show that you are signaling. I have since install had them in the water with no issues. They seem to be sealed well from water and mud.

Good looking lights and quality rubber grommets. They are thicker grommets than some competitors Just be aware that LEDs are sensitive to how they are wired. diodes are directional and only allow current to flow in one direction. So if you connect the negative and positive in the wrong order, they won't work. At least on the lights I received, the white wire is for ground/negative and the black should be wired to positive. Hopefully that saves some folks from getting frustrated when they don't light up.

Light went out in a few months but ordered the same one to replace and will see if it lasts

The lights are great, I used one with the EAG spare tire delete kit for the Jeep JK. I was able to drill out one of the rubber plugs that came with that kit to rig this up as my new 3rd brake light. The only frustrating thing was that the black wire was hot and the white wire was ground which I didn’t figure out until I looked at the photo in the listing. Once I flipped the wires the lights worked great.

Put 3 of these in my custom front bumper. They fit great into the 3/16” thick, 3/4” diameter hole. Very bright at first and look good too. They are now less than a year old and need replaced. The rubber grommets are all cracked and brittle and the leds themselves are dim and flickering. Will look for different brand for sure.

Amazing stuff

Needed these for my imported truck for marker lights. Had to purchase red ones in the end, but these would have been pretty awesome.

Look great

Have these installed on my motorcycle and haven't even put 100km on the set of these signals and one of them have already burnt out. I barley ride the bike and got pulled over with the officer informing me know its burnt out. Look great but the quality of the bulb doesn't last very long. LED's normally have a 10,000 hour life expectancy and barley did a fraction of that......