XMSJSIY 3.5mm Terminal Block Cable, 1/8 Inch TRS Stereo Solderless Screw Terminal Speaker Wire 3.5mm 3 pole Male to 3Pin Bolt Headphone Balum Patch Cord (2 Pack-32CM)

This works as advertised. I needed to go from 3.5mm to open leads. This did exactly that.

I have a pair of EJEAS motorcycle intercoms that I wanted to use with a standard headset in my sports car. The intercoms speaker and mic plug in using a standard 3.5 jack, however, the intercoms also charge with a 3.5 jack also so I knew they weren’t wired the same. Figuring out what they used for power and ground wasn’t hard, just used my multimeter on the charger. I had cut a headset cable in the past but the wires were just too flimsy and fragile to work with. I bought this and a female pigtail so I could plug into both ends without harming anything and experiment with the wiring at junction block. Once all was figured out, I soldered and shrunk wrapped two pigtails together for the final adapter. A bit of work and a bit of money but I ended up with what I wanted.

Great for testing cables and pins before you solder. Block is too big to use on headphones or headsets, but it is a great testing tool.

I use these to go from the 3.5 mm jack tonspeaker wire. They are well made. And do the job.

Does the job well. Even got another mini screw driver.

Once again no instructions, 4 holes 2 labeled. We as consumers have to start sending stuff back with zero instructions, its lazy, were paying high dollar right now and a 2x3 piece of paper cost about 2 cents. I'm just collecting a datasheet of buyers i will not buy from again, and i'm a heavy buyer for my robot builds.

Fast shipping, great product, works perfectly

These did not work the way I thought they would, but they seem like a great piece of equipment.

Broken cable going to my speakers. I could have just used a new plug I already have (from the days that I thought it was neat to fix things elegantly) and soldered the existing wire to it. But I just can't be bothered with a finicky small soldering job like that, and this is a great workaround. Yes, it is not elegant, and it's bulky, but it's something that sits in the background and done in a minute. I have other similar connectors, always good to have. One thing to note, stripped wires are nowadays often of very high gauge (low thickness) so with a pressure connector like this one, you may have to fold it over itself to get it as thick as needed to hold it.

Well made and as described. Screwdriver provided in the package for the terminal block was without a tip (flat or philips). Was just a thin cylindrical metal rod with a hard plastic handle.

super

I like the simplicity