Reloading Primer Pocket Reamers Large/Small
C**9
Great tool for its purpose
These are a great tool for primer pocket cleaning - for brass with both large & small primer pockets. I chuck these in a corded drill with variable speed. All it takes is a second at low speed to get all the crud out of the primer pockets. The machining is also well done - sturdy & robust. I only wish they would sell individual tools - these only seem to come in the large/small package pairing.
G**R
Light Years ahead of OE tubes
The machining on these tubes is exquisite. The part that should be replaceable IS replaceable. Way less money than inferior factory tubes.
D**N
Built right
Works like it should
J**S
Great Product
Sharp
J**.
Great quality
This is a quality tool. Sharp edges and works great.
K**R
Quality tool
Perfect size and price.
M**N
Good solid product
Does not fit flush with the Lyman hand tool however it still works.
B**N
Will not fit Hornady
Genuine Hornady is second from right. The pin to the right is too wide for a Hornady system.The three to the left I was able to make fit by filing the heads down slightly. The manufacturer needs to take a little more off the size of the head and it would be a good product.I had asked if these would fit a Hornady press and was assured that they would, unfortunately this was not the case.The manufacturer was prompt in issuing a refund to me and I would happily purchase again if the pins are retooled to fit a Hornady system as obviously a very honest retailer.Perhaps they will rectify this in future production runs.
A**R
Better than lee
These decappers are direct replacement for your lee press. They seem much sturdier than the junk lee ones that break very easily. Deprimed 100 cartridges already and I can immediately feel the difference.
R**C
Clean pockets
These work much better than the blade, or brush style. 🤔 think they'll last longer also.
D**E
Great Value Product
Far more economic for the whole set then the 10 per pilot in the other brand. They have one very simple job and they do it fine. There may be the oddball size like the 6.5mm and .40 pilots that should be included, and be sure you check size of your cutter's pilot hole because there's two options.
V**N
quality of lights
I used this product for 1 week and lights quit.
A**R
reliable
McJ is an excellent tool maker ; never worry about buying any of their products
ترست بايلوت
منذ 5 أيام
منذ شهر