AKK TS832+RC832 5.8G 2000M Range FPV Audio Video Transmitter and Receiver for FPV Drone

This works very well. I added it to my Flexify drone and have great video now to my tablet. I have not maxed out the distance so far and probably cannot with the range of this drone. Easy setup, easy channel change on both the tax and rx. Clear video. It get very warm but that is the norm for any of these receivers. Quality buy!

Great system, I also ordered the recommended cloverleaf antennas. The RX and TX jacks are RP-SMA which you can see in my pictures that are attached. I haven't maxed out the distance yet, but traveled about 1 1/2 mile and didn't even have static or "snow" in my goggles image. This is very impressive because I have had much more expensive setups that couldn't do that!

transmitter seems ok, not range tested. receiver does not come up on standardized video devices at same frequency settings as transmitter. still testing both items in package

The RC832 RX & TX are easy to set-up compared to the older Sony board cameras and RC305 RX with dip switches. Everything worked well and they came with all necessary wiring to hook up out of the box, very pleased with that. I let all components burn in for 30 minutes and found one thing that concerns me, they run hot @ 127 degrees F! I posted a question about it and received a reply that the normal run temp range is 90-100 C (194-212 F)! Damn, that's smoking hot and I can't believe that will not effect long term reliability, we'll see as I haven't flown mine yet just put them through a static burn in "literally"! The big question that remains, will they have the range?! It is a nice combination with good features and as long as you don't mind the excessive heat you'll be good to go. I will update when I have more experience flying with the units...

This works pretty well for the price . Good bandwidth, clear picture on receiver. Kind of a better hog but that’s expected for the range it gets.

can not get the receiver to work, burnt up after just a few minutes of being plugged in to 3s lipo 12v

Used the receiver. Works great with 25mW cam/transmitter. Easy to use. Composite out only is a bit disappointing.

I purchased 2 of these units. same issues with both and interchanging the pair. And yes they work for very short range. Both transmitters are working on regulated 12VDC with less than 100mV drift. And the transmitters run extremely warm - perhaps I could fit aftermarket cooling or heat sink if I found a line of sight application less than 400mt As in the description states "2000mt range" I was hopping for half of this considering the price being to good to be true. But line of sight (LOS) struggled to maintain signal at 450mt. The video output signal voltage does appear to run slightly high over a 75R resistor load which also explains why an older monitor I originally used for testing wouldn't work, Lucky for me the cheaper generic monitor I have with built in buffer resolved this problem. I have considered directional antennas, but I think these will be tossed in the box labelled of "crap for another day" If you are going to purchase, don't expect miracles, or even its own specifications to be close to accurate.