Modtek Curtain and Drapery Ring Slide-Solves Shower and Drapery Rings from catching Allowing Them to Slide Smoothly and Quietly (12 Ft Clear)

This completely solved one of my daily annoyances: Curtain rings catching on the rod and making a horrible scraping racket every time I opened or closed them. With these, the curtains glide smoothly and quietly with almost no effort. It was easy to install and made an immediate difference. It honestly feels like such a small upgrade, but the improvement in function (and noise reduction) is huge. This is absolutely going on every curtain rod in my house going forward. If you’re tired of fighting with stuck, noisy curtain rings, these are 100% worth it.

I have tab type curtains that wouldn't slide easily on the rod. This plastic tape stuff makes the curtains slide. Easy to install. Recommend.

I rarely take the time to write reviews, but I’m here and If there were more than 5 stars to give, I would. This stuff took my frustrating to move ring hung curtains and made them the smoothest gliding, quiet, joy to open and close. You can’t notice it unless you’re really looking for it, and it was super easy to put on (I took the rod down and moved all the rings to one side, put the tape on as much as I could then slid them down to the other side and did the rest of the rod). Awesome quality, look, and value. I’m admittedly super picky, I like quality at a decent price, and this one hits the mark- I would definitely buy again and recommend.

Works absolutely perfect. I first made the mistake of cutting it too short. It must be installed all the way across the entire rod. I have it on three rods and all glide like butter! I would also recommend that you have the curtain rod already installed on the wall so that you know where on the rod the tape should go. It is virtually invisible. Great product!

I purchased these for the curtains on our patio door and it was the best purchase! Our patio door gets used a lot everyday. My kids and husband would just yank on the curtains which would pull the curtain rod despite screwing them tight and even short gluing the rod to the bracket. I was tired of having to push it back or if I didn’t the rod would fall. Adding this was easy and makes our curtains glide easily over the rod. I haven’t had to move the rod at all since adding this.

Before ordering, be sure that there is room between the rod and the curtain or drapery ring to accommodate the thickness of the tape. Mine did not; I had to order a thinner product. The concept is great. The drapes slide smoothly and quietly rather than the metal-on-metal sound. The application can be tricky depending on the length of the rod and whether or not you can take it off the wall to apply the tape without having to work around the curtain/drapery rings.

I have a 10ft ceiling in the living room and hung my curtains recently. Right after I hung them, I noticed how hard it was for me to slide my curtains across the curtain rod at the joints. It's also due to how high the rods were hung off of the floor (I have a similar curtain rods in the bedroom, and I only hung it around 8ft off the floor. I had no issues to pull my curtains because I was able to lift it up a bit when I pull so the curtains rings just 'jump' through the joints) . I did some research online and came across this product. With a little hesitation, I placed an order on the 24 ft one because my curtains rods are 180 inches long. I installed it according to the instruction right after I received it. A small tip I used is that I first used some tape to tape down my curtain rods to the floor after I took them down, so they don't roll around when I apply this product. Then I pulled the length needed for my rods plus a few extra inches, and then use painter's tape again to tape it to the spot I want it to be applied to. I used a few small pieces of tapes along the rod to do it so when I peeled off the red backing and press it down to my rod, I can ensure it'd form a straight line from one end of the rod to the other. Then I just did a small section at a time - cleaned the rod with the wipe, waited until it's dry, peeled the red backing, and pressed this product down to make sure it adhered to the rod. After doing all of these, I put up my rods and curtains right away and gave it a try. It worked like a wonder!! Not only the curtain rings had no problem going over where the rods joined, it also became so quiet because my metal curtain rings are no longs sliding on the metal curtain rods, which helps to reduce the noise. Job well done!!

Easy to install. The slide of metal curtain hangers on metal rod is now smooth and quiet.

Ease of intallation

Muy buena cinta deslizante y fácil de colocar

Did I overpay since this is essentially sticky plastic? Yes. Is it also the best nonessential item I’ve ever bought? Absolutely. My partner and I love this thing. My curtains glide like butter. It’s insanely satisfying. I want to buy one for every curtain in the house.

This stuff is great, we have a bar in our shower and there’s a lip that the rings kept getting caught on. I thought either try this or get a new bar. This works amazing, it’s held strong even in the humidity of the bathroom.

I have an adjustable curtain rod and my heavy insulated drapes would be difficult to open and shut. They kept getting stuck on the adjustable part of the rod. Once I attached the strip they glide very easily.