Description:
The STLINK-V3MINI is stand-alone debugging and programming mini probe for STM32 microcontrollers.
The JTAG/SWD interfaces are used to communicate with any STM32 microcontroller located on an application board.
The STLINK-V3MINI also provides a Virtual COM port interface allowing the host PC to communicate with the target microcontroller through one UART.
The STLINK-V3MINI is a portable version, easy-to-use debugger/programmer including STDC14 interface with its flat cable.

Supported Software
STM32CubeProgrammer
Keil MDK-ARM
IAR EWARM
SW4STM32
STVP
GCC-based IDEs

Supported Devices
All STM32 MCUs with JTAG / SWD interface

Connect to PC
The STLINK-V3MINI should be connected to the PC via a USB Micro-B cable.
* Before connecting, install/update the ST-LINK toolset to support the STLINK-V3MINI (drivers)
* STLINK-V3MINI adopts an STM32 F7 microcontroller, supports USB2.0 high speed communication

LED Status
COM LED is blinking RED: the first USB enumeration with the PC is taking place.
COM LED is RED: communication between STLINK-V3MINI and the PC is established (end of enumeration).
COM LED is blinking GREEN/RED: data are being exchanged between the target and the PC.

Package Contains
STLINK-V3MINI official content x1
STLINK-V3MINI Adapter x1
USB type A plug to micro B plug cable x1
20-pin JTAG/SWD flat ribbon x1
3-pin 2.54mm pitch squid wire x1

For more resources you may need, pls contact me via message, i will send you then via attachment.

Brand	XYGStudy
Package Dimensions	13.5 x 9.8 x 4 cm; 112 g
Manufacturer	XYGStudy
Color	SIM7600G-H 4G HAT
Processor Brand	ARM
Memory Technology	DDR4
Memory Clock Speed	2133 MHz
Are Batteries Included	No
Item Weight	112 g

STLINK-V3MINI Microcontrollers ST STM32 MCU JTAG SWD USB Compact Stand-Alone in-Circuit Debugger Programmer Connect to PC with USB Micro-B Cable Onboard STDC14 Connector @XYGStudy

التفاصيل

الوصف

المواصفات

الأسئلة الشائعة