Blind Hole Collet Bearing Race and Seal Puller Extractor Kit, Slide Hammer Pilot Insert Inner Internal Bearing Removal Tool Set, 16PCS

Essential item in my garage now following complete bike rebuild including virtually all bearings. A few tips and techniques had to be learned to get the best out of it but overall very positive and good value.

Excelente producto lo mejor para sacar bujes de sigueñal

I had to remove a needle bearing from a front differential so I bought and tried this tool. After a light learning curve, I was successful in removing the bearing. I subsequently used it to remove two axle seals in which it worked well. For the time and low amount of effort it took the tool was well worth the investment, I consider it paid for. Depending on the bearing, don't expect the bearing will necessarily survive the extraction as you are pulling on the inner race, but then again it isn't common practice to remove 'good' bearings. Seals will also be damaged, but you should never plan to reuse a seal either. All in all a good tool, made of hardened steel. Comes with a short slide hammer (limited use) and a two jaw puller which works well at a smooth consistent pull not creating shrapnel. FYI you will need about a 1/8" to 3/16" of space minimum behind the bearing/seal for the tool to penetrate and grab.

This product deserves a 10 star. Save me hundreds. OEM tool from for to replace the axle racer was $350. This one comes with all kind of sizes and it works just fine. Only con is that the puller is too short, but works fine.

Bought this to remove half shaft oil seals . It took longer to remove the plastic film what the case arrived in than it did to remove the seals good tool easy to use and does the job