3 Buttons Replacement Key Fob Cover Fit for Honda 2003-2012 Accord 2006-2013 Civic EX 2009-2015 Pilot 2005-2006 CR-V Ridgeline Odyssey Keyless Entry Key Fob Case Shell

Great and sturdy case. Along with the electronics and key… MAKE SURE to remove the immobilizer chip from the original case and place it into the new case.

Purchased this for my boyfriend because his key was loose since the other remote had broken off. This saved us like 80-90 bucks that would have cost us to get a new remote. It was really easy to install and for the value you can’t go wrong. I also purchased a silicone cover so that hopefully this one lasts him a little longer.

Not worth the money. It didnt last long.

Works very well, great quality. Take care to slide the key sleeve into place in the fob, not push it in, otherwise it won’t fit properly. I had to fiddle with it for a bit until I figure that out and it fits together better than new. 5 stars

The media could not be loaded. I purchased this when my OEM key fob cover cracked and needed replacing. This cover saved me from being key/carless, but it was a huge hassle to get it to snap together, and is essentially being held together solely by the tiny screw it comes with (and I can already see the plastic starting to crack from the tension). I'm not sure how long it'll be before it snaps again, but this was an affordable replacement for a quick fix. It also didn't come with the "Honda" stickers mentioned on the listening, but I don't personally mind that so much.

This was a bit hard to install, took some cleaver leverage with the screw driver. Now, this was for my husband, who unfortunately has very strong hands, but the original key case (from the dealer) did last years where as this one survived a week before suffering the same damage as the original key case. But it did fit the key and chip perfectly.But warning, there are one way clips that have to be snapped first, and it helps to snap the key part into one side before snapping them together.

Its a bit tricky to put together, you cant just sandwich it all together and force it. You have to slide the key holder into the one half of the case before snapping the two halfs together. Watch a vid if confused. Once together, quality is excellent and feels stronger than the factory one.

Ok, I read a lot of reviews and when trying to fix my key it took hours! But i finally figured it out. You have to attach the side that doesn't have the slit and then press down the other side hard. It fits I promise just not up and down.